Install O V E N, Oven Door Reinstallation

I N S T A L L A T I O N

E L E C T R O N I C I G N I T I O N I N I T I A L L I G H T I N G

Range burners use electronic igniters in place of standing pilots. When the range control knob is pushed in and turned to the "HIGH" position, the system creates a spark to light the burner. This sparking continues until the electronic ignition senses a flame.

•Check operation of the range burners. Push in and turn each control knob to "HIGH" position. The flame should light within four seconds.

•If burners do not light properly, turn control knob to the "OFF" posi- tion. Check that burner head is in the proper position. Check that the unit is properly wired to house supply and that the circuit breaker or house fuse has not blown. Check that the shut- off valve is in the "ON" position. Check operation again. If a burner does not light at this point, contact your dealer for assistance.

R E I N S T A L L O V E N

D O O R ( S )

Ovens door(s) have been removed according to the procedure described on pages 4-5. Follow these instruc- tions to reinstall.

Oven Door Reinstallation:

•Grasp the oven door on opposite sides and lift it until the door hinges are aligned with the openings in the oven frame.

•Holding the door at about a 30- degree angle from the vertical, slide the hinges into the openings until the bottom hinge arms drop fully into the hinge receptacles.

IMPORTANT NOTE: Fully extend the hinge claw, which is opposite the hinge pin location, and insert into hinge pocket prior to inserting oppo- site side. This will ease installation of door.

•Lower the door to the fully opened position. Remove pin from the appropriate hinge arm.

•Reinstall the plate and screw over the hinge claw. Refer to the following illustration.

•Open and close the door com- pletely to ensure that it is properly installed.

•For 48-inch and 60-inch units, complete this procedure for both the left and right oven doors.

PLATE	SCREW
HINGE
PIN

Reinstall Oven Door