InstalltheTank
1.Position the tank vertically beneath the faucet so that the longer ¹⁄₄" (6.4 mm) tube from the faucet reaches the easy- connect fitting on the top of the tank.
IMPORTANT: The tank must be positioned so that the tube from the faucet does not kink.
2.On the wall, mark the location of the top of the tank. Set the tank aside.
3.Mark a second line 2¹⁄₄" (5.7 cm) below the first line.
4.Align the bottom of the mounting bracket with the lower line.
A
C
B
A. 2¹⁄₄" (5.7 cm)
B. Mounting bracket
C. Off position on the temperature control
5.Use 2 screws (and wall anchors if needed) (not provided) to fasten the mounting bracket to the wall.
6.Hang the tank on the bracket.
IMPORTANT:
■Do not plug the power supply cord into the 3 prong outlet at this time.
■Do not stretch, twist or tightly bend the tube.
■Do not use any sealing compounds.
7.Connect the longest ¹⁄₄" (6.4 mm) faucet tube to the rear
8.Push the tube straight into the fitting as far as it will go. Pull on the tube to verify that it is secure and properly installed.
Easy-Connect Fitting
AB
NOTE: To remove the tube from the
A
B
C
A. Faucet tube
B. ¹⁄₄" or 7 mm
C.Collet
9.Using pliers, spread open the hose clamp (provided) and slide the clamp about 2" (5.1 cm) onto the largest diameter faucet tube.
A
B
C
A.Largest diameter tube
B.Hose clamp
C.Tank outlet tube
10.Push the tube down onto the tank outlet tube as far as it will go.
11.Using pliers, position the hose clamp so that it is close to the end of the tube.
A
A. Hose clamp
A. Faucet tube
B. Collet
6