Product support
A solid soffit or a wood block is required to prevent the refrigerator from tipping forward after it is installed.
Determine what height the refrigerator will be when it is installed to fit opening. Determine the height to the top of the cover at the final installed height you plan to use.
| wood |
|
, | block(a) |
|
!/I l\\\\\lj/fl | Block(s) | ml’*t |
| be lorig.enough | |
| to fully | cover |
| wldth of cover. | |
0 El&k(s)
It over cover.
. f.
cover
Personal Injury/Property
Damage Hazard The solld soffit must be no more than 1” (25 mm) above the cover or you will need to attach a wood block to the wall.
Fallure to attach wood blocks to the wall could result In personal Injury or property damage.
Your installation location may vary from the examples shown. However, you must support the refrigerator with a wood block or other adequate means of support located l/4”
(6 mm) above the cover.
Locate wood block. a mexlmum of l/4”
l offlt | - |
|
|
|
(more | than 1” |
|
| rofflt- |
(25 mm) above |
|
| r12eimfi;n 1” | |
cover) | , wood | block(s) | above cover) | |
|
|
|
| |
| ,114” | (6 mm) |
| |
| - | max. | - cover | |
|
|
|
| |
| \ | cover |
| |
\ rear wall | \ re r wall |
When a sofflt Is not avallable, locate wall studs in the refrigerator opening. Center one wood block and use wood screws to attach the wood block to the wall studs. Make sure screws engage wall studs a minimum of
Page 7
If soffit Is more than one inch
(25 mm) above cover, locate wall studs in the refrigerator opening. Center one wood block and use wood screws to attach the wood block to the wall studs. Make sure screws engage wall studs a minimum of
If soffit Is less than one Inch (25 mm) above cover, a wood support is not needed.