Top view
top grille decorative panel assembly,
two small screws and panel side trim from one side of the decorative panel
assembly to allow
insertion of your
custom panel. Reassemble the side trim, screws, and tethers in reverse order. Reinstall decorative panel assembly and pull down to secure.
If side panels are not used, 16. go to Step 17.
If
Top view
-
(62 cm) max.
L
l Outside side trim piece: Drill 6
equally spaced holes into side trim
piece. Do Not drill into side of
appliance. Attach a support board to trim piece. Nail front and rear edges of side panel to support boards. Cover front support board with a matching panel piece.
Top view
\ rear wall
\
support board
- side panel
Open appliance doors and 17 . remove protective film from door frame. Recheck water connections at bottom of refrigerator for leaks.
Attach bottom grille to cabinet with two screws. Install shelves and bins in refrigerator and freezer compartments.
Set refrigerator and freezer
18. compartment controls to the midpoint between “COLD” and “COLDEST.” Check that the compressor is operating properly and that all five lights are working.
I
24-
side trim
door
(62 ;m) max.
l Inside side trim piece: Slide front edge of routed side panel into trim piece. Nail rear edge of panel to support board.
If
Part No. | 2004022 | KPtchenAid” |
| |
0 | 1995 | KitchenAid. | HOME APPLIANCES |
|
8 | KitchenAid. Registered | trademark | Printed in U.S.A. | |
| of KitchenAid. | Prepared by KitchenAid, St. Joseph, Michigan 49085 | ||