KitchenAid 2225033A, 12642708SP manual Base Grille, Refrigerator Doors

Page 6

7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing into a bucket or sink. Turn ON main water supply and flush out tubing until water is clear. Turn OFF shutoff valve on the water pipe. Check for leaks. Coil copper tubing.

Connecting to Refrigerator

1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing.

2.Create a service loop using extreme care to avoid kinks. Secure copper tubing to refrigerator cabinet with a “P” clamp.

1

2

3

4

5

1.Copper Tubing

2.“P” Clamp

3.Compression Nut

4.Compression Sleeve

5.Water Valve Inlet Port

3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

4.Plug in refrigerator or reconnect power.

5.Push refrigerator into opening.

Base Grille

Removing the base grille

1.Grasp the grille with both hands.

2.Pull up on the bottom and tilt it toward you.

3.Pull down to release the top of the grille.

Replacing the base grille

1.See markings on inside of base grille for proper placement.

2.Snap the top of the grille into place first.

3.Press down and in on the bottom of the grille until it snaps into place.

Refrigerator Doors

Handle Removal

(Graphics are included later in this section.)

1.Using a ³⁄₃₂ in. Allen wrench, loosen the 2 set screws located on the side of each handle.

2.Pull handle straight out from the door. Make sure you keep screws for reattaching handles.

Freezer Drawer Removal

(Graphics are included later in this section.)

1.Open freezer drawer to full extension.

2.Remove all articles from baskets.

3.Slide top wire basket out to full extension and lift out to remove.

4.Remove the bottom wire basket by pressing the release button on each side and lifting the basket from the rail guides.

1

1. Release button

6

Image 6
Contents Table of Contents/Table des matières BOTTOM-MOUNT RefrigeratorUse &CareGuide Table of Contents Table DES MatièresRefrigerator Safety Before you throw away your old refrigerator or freezerUnpacking Refrigerator InstallationCleaning before use Location RequirementsWater Supply Connection Connecting to Water LineElectrical Requirements Recommended grounding methodBase Grille Refrigerator DoorsDoor and Hinge Removal Freezer Drawer ReplacementDoor and Hinge Replacement Door Reversal on some modelsDoor Swing Reversal optional Architect SeriesNormal Sounds Refrigerator USEDoor Closing and Alignment Ensuring Proper Air CirculationIce Maker Using the ControlsAdjusting Control Settings Turning the Ice Maker On/OffMeat Drawer and Cover Refrigerator FeaturesRefrigerator Shelves Crisper and Crisper CoverCrisper Humidity Control Freezer FeaturesUtility or Egg Bin Freezer BasketsDoor Retainer Door FeaturesIce Shelf Door BinsRefrigerator Care CleaningCleaning your refrigerator Changing the Light BulbChanging the Freezer Light Bulb Power InterruptionsVacation and Moving Care If you choose to turn the refrigerator off before you leaveTroubleshooting Off-taste or gray color in the ice on some models Temperature is too warmIce maker is producing too little ice on some models Divider between the two compartments is warmU.S.A Assistance Or ServiceAccessories CanadaKitchenaid Refrigerator Warranty KitchenAid will not pay forSécurité DU Réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurDéballage Installation DU RéfrigérateurEmplacement d’installation Nettoyage avant l’utilisationRaccordement de la canalisation d’eau Méthode recommandée de mise à la terreSpécifications électriques Arrivée d’eau froideRaccordement à une canalisation d’eau Raccordement au réfrigérateurGrille de la base Portes du réfrigérateurÉtapes finales Remplacement de la porte et des charnièresEnlèvement de la porte et des charnières CaisseInversion du sens douverture des portes option Série ArchitectFermeture et alignement des portes Sons normauxFermeture des portes Utilisation des commandes Pour s’assurer d’une circulation d’air AppropriéeRéglage moyen Mise en marche/arrêt de la machine à glaçons Ajustement des réglages de commandeMachine à glaçons Augmentation du taux de production de glaçonsTablettes du réfrigérateur Tiroir à viande et couvercleBac àlégumes et couvercle Réglage de l’humiditédans le bac à LégumesCasier utilitaire ou oeufrier Tablette àglaçons Caractéristiques DE LA PortePaniers de congélateur Dispositif de retenue de la porteCompartiment utilitaire Entretien DU RéfrigérateurBalconnets dans la porte NettoyageRemplacement de l’ampoule d’éclairage Remplacement de lampoule du compartiment de congélationRemplacement de lampoule du compartiment de réfrigération Vacances Pannes de courantEntretien avant les vacances ou lors d’un Déménagement DéménagementLe plat de dégivrage contient de l’eau DépannageLes ampoules n’éclairent pas Le moteur semble fonctionner excessivementIl existe une accumulation d’humidité à l’intérieur La cloison entre les deux sections est tièdeLa température est trop tiède Les portes sont difficiles à ouvrirAssistance OU Service AccessoiresGarantie DU Réfrigérateur Kitchenaid KitchenAid ne paiera pas pourAll rights reserved