KitchenAid LI3Y7C, W10322991C installation instructions Install Vent Covers, Complete Installation

4.Run home power supply wiring through ¹⁄₂" strain relief into terminal box.

E

D

C

B

A

A. UL listed wire connectors B. White wires

C. Black wires

D. Green (or bare) wire connected to yellow-green wires

E. Home power supply

5.Use UL listed wire connectors and connect white wires (B) together.

6.Use UL listed wire connectors and connect black wires (C) together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire in terminal box.

Failure to do so can result in death or electrical shock.

7.Connect green (or bare) ground wire from home power supply to the 2 yellow-green ground wires (D) in terminal box using UL listed wire connectors.

8.Tighten strain relief screw.

9.Install terminal box cover.

10.Reconnect power.

Install Vent Covers

1.When using both upper and lower vent covers, push lower cover down onto hood and lift upper cover to ceiling and install with 2 - 2.9 x 6.5 mm screws.

NOTE: For vented installations, the upper vent cover may be reversed to hide slots.

D

C

C A

B

A. Upper vent cover

B. Lower vent cover

C. 2.9 x 6.5 mm screws

D. Bracket

Complete Installation

1.For non-vented (recirculating) installations only, install charcoal filters over grille on blower housing. See the “Range Hood Care” section.

2.Install metal filters. See the “Range Hood Care” section.

3.Check the operation of the range hood blower and light. See the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.