KitchenAid Pro LineTM installation instructions Use and Care Information, Check operation

Page 8

16. Install the filters.

Remove the filters from the box and remove the white protective coating from the filters.

Note: Use two hands to install filter, one to pull and turn the knob, the other to hold the filter in place so that it doesn’t fall onto the cooktop.

Grasp one of the filters so that the knob faces down and toward the back of the hood.

Insert the filter end without the knob into the retaining channel in the front of the hood.

Pull and turn the knob to the left (counterclockwise) so that the locking lever does not protrude from the filter.

Insert the knob end of the filter into the retaining channel in the back of the hood.

Turn the knob to the right (clockwise) to lock the filter in place.

Repeat for remaining filters.

Check operation

17. Turn power on.

18. The canopy hood controls are located on the right- hand underside of the canopy.

controls

filters

19. Check the operation of the range hood:

Move light switch to

“1” position. The light should turn on.

Move blower switch to “1” position. The blower should operate.

Move the blower speed switch to: “1” position for low speed, “2” position for medium speed, or “3” position for high speed.

Move blower and light switches to “0” position to turn blower and light off.

If range hood does not operate:

Check that the circuit breaker is not tripped or the house fuse blown.

Disconnect power supply. Check that wiring is correct.

To get the most efficient use from your new range hood, read the “Use and Care Information” section.

Keep your KitchenAid

Installation Instructions and Use and Care Guide close to range hood for easy reference.

Use and Care Information

WARNING — To reduce the risk of

WARNING — TO REDUCE THE

SMOTHER FLAMES with a close-

fire or electrical shock, do not use

RISK OF A RANGE TOP GREASE

fitting lid, cookie sheet, or metal

this fan with any solid-state speed

FIRE:

tray, then turn off the burner. BE

control device.

Never leave surface units

CAREFUL TO PREVENT BURNS. If

WARNING — TO REDUCE THE

the flames do not go out

unattended at high settings.

immediately, EVACUATE AND

RISK OF FIRE, ELECTRIC SHOCK,

Boilovers cause smoking and

CALL THE FIRE DEPARTMENT.

OR INJURY TO PERSONS,

greasy spillovers that may ignite.

 

OBSERVE THE FOLLOWING:

Heat oils slowly on low or

NEVER PICK UP A FLAMING PAN

Use this unit only in the manner

medium settings.

— You may be burned.

 

 

intended by the manufacturer. If

Always turn hood ON when

DO NOT USE WATER, including

you have questions, contact the

cooking at high heat or when

wet dishcloths or towels — a

manufacturer. Before servicing or

cooking flaming foods.

violent steam explosion will

cleaning unit, switch power off at

Clean ventilating fans frequently.

result. Use an extinguisher ONLY

service panel and lock the service

if:

Grease should not be allowed to

disconnecting means to prevent

 

accumulate on fan or filter.

You know you have a Class ABC

power from being switched on

 

extinguisher, and you already

accidentally. When the service

Use proper pan size. Always use

know how to operate it.

disconnecting means cannot be

cookware appropriate for the size

 

locked, securely fasten a

of the surface element.

The fire is small and contained in

prominent warning device such as

WARNING — TO REDUCE THE

the area where it is started.

a tag to the service panel

 

RISK OF INJURY TO PERSONS IN

The fire department is being

CAUTION: For general ventilating

THE EVENT OF A RANGE TOP

called.

use only. Do not use to exhaust

GREASE FIRE, OBSERVE THE

You can fight the fire with your

hazardous or explosive materials

FOLLOWING:

back to an exit.

and vapors.

 

 

 

8

Image 8
Contents Table of Contents Quick ReferenceYour safety and the safety Others is very important Tools needed Parts neededParts supplied Important Observe all governing codes and ordinancesFor the most efficient and quiet operation Product dimensions Cabinet dimensionsVenting requirements Venting methods Calculating the vent system lengthPreparation Installation stepsElectrical requirements 48 121.9 cm hood 30 76.2 cm hood36 91.4 cm hood 42 106.7 cm hood Do Not turn on power until installation is completed Electrical connection5b.If chimney extension is Failure to do so can result in death or electrical shockUse and Care Information Check operationOperation CleaningOptional Installation Kits available from your dealer Wiring diagrams WarrantyLength of Warranty Limited ONE-YEAR WarrantyRequesting Assistance or Service Our consultants provide assistance withIf you need service Listed in Check OperationRéférence rapide Table des matièresUne prise de courant électrique reliée Pièces fourniesOutillage nécessaire Dimensions du produit Pour un fonctionnement efficace et silencieuxConfigurations de circuit de décharge Calcul de la longueur effective du système de déchargeLes étapes de l’installation Contacter un électricien qualifié pour l’installationAlimentation électrique PréparationInstaller seulement les brides. Ne pas installer la hotte Hotte de 121,9 cm 48 poRaccordement au réseau électrique ’assurer que la hotte est fixée solidement au murUtilisation et entretien Utilisation de la hotte NettoyageSchémas de câblage Garantie Hotte d’aspiration KitchenAidDurée DE LA Période DE Garantie Garantie Limitée D’UNE AnnéeDemande d’assistance ou de service Si vous avez besoin de serviceDe dépannage 30 et 18 h 00 HNE, en composant

Pro LineTM specifications

The KitchenAid Pro Line™ series represents the pinnacle of culinary innovation, designed specifically for passionate home cooks and culinary professionals alike. With a robust combination of cutting-edge technology, superior materials, and aesthetic appeal, the Pro Line™ collection offers appliances that empower users to elevate their cooking experience.

One of the flagship products in this line is the KitchenAid Pro Line™ mixer, which is renowned for its powerful motor that boasts a significant wattage capacity, delivering unparalleled mixing capabilities. This high-performance motor ensures that the mixer can handle even the heaviest of doughs, offering a seamless mixing experience for bread, cakes, and pastries. The integrated bowl-lift mechanism is designed to provide stability and easy access, allowing users to add ingredients without hassle.

As part of its commitment to versatility, the Pro Line™ mixer features an extensive array of attachments that can be swapped out effortlessly. From pasta makers to food grinders, these accessories expand the functionality of the mixer, making it a multifunctional powerhouse in any kitchen. The innovative design of the mixing bowl, often crafted from stainless steel, provides both durability and an easy-clean surface, while featured handles ensure easy grip and stability during use.

The Pro Line™ series also emphasizes precision with its variable speed control, allowing users to achieve the exact texture and consistency they desire. The soft-start feature minimizes splatter, while the lock and unlock functionalities enhance safety during operation.

In addition to performance, aesthetics play a significant role in the Pro Line™ design philosophy. Available in a variety of colors and finishes, these appliances are crafted to be both functional and visually striking, capable of complementing any kitchen decor.

Moreover, KitchenAid’s Pro Line™ products are built with premium materials, ensuring longevity and resilience in rigorous cooking environments. With a commitment to quality and performance, the Pro Line™ series redefines what consumers can expect from kitchen appliances, merging style with groundbreaking technology to inspire creativity and confidence in the kitchen.

Overall, the KitchenAid Pro Line™ stands as a testament to the brand's dedication to culinary excellence, making it an essential addition for any cooking enthusiast looking to enhance their kitchen capabilities.