KitchenAid Slide-out Vent Hood installation instructions Accessories

Page 9

Exterior surfaces

Clean the vent hood with a mild detergent and soft cloth. Do Not use abrasive cleansers or steel wool pads.

Filters

For best results, clean filters often. Pull tabs downward to remove filters. Place filters in dishwasher or hot sudsy water to clean.

Replacing the bulb

KWVU and YKWVU model series:

screws

GZ and YGZ model series:

screws

1.Remove screws above light cover and set aside.

2.Pull light cover forward slightly and then downward to remove cover.

3.Replace light bulb. Use a

15-watt fluorescent bulb with 30"

(76.2 cm) unit and 18-watt bulb with 36" (91.4 cm) unit.

4.Lift cover back into position. Replace screws.

Operating of vent hood

For best results, turn vent hood fan on at beginning of cooking and allow it to run until all smoke and odors are removed from room.

KWVU and YKWVU model series:

light button

 

speed buttons

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To turn fan ON:

Slide glass shelf forward. Press the fan “speed” button for the desired speed. Speed may be increased, decreased, or turned off anytime during vent hood operation. The indicator light next to “speed” button selected should be on when the fan is running.

To turn fan OFF:

Press the “0” button or close the glass shelf. The fan will shut off when glass shelf is about 2"

(5.1 cm) from the closed position. When the glass shelf is opened, the fan will operate at the last setting.

To turn vent hood light ON:

Open the glass shelf about 1"

(2.5 cm). Press the “light” button. The light will be on each time the glass shelf is opened. The light can be used for a night light by opening the glass shelf about 1" (2.5 cm).

To turn vent hood light OFF:

Press the “light” button to turn the light off. Or close the glass shelf.

GZ and YGZ model series:

light switch

fan switch

 

indicator

 

light

 

speed

 

switch

To turn fan ON:

Slide glass shelf forward. Move the “fan” switch to “1”. Move the “speed” switch to desired setting. The speed may be increased, decreased, or turned off anytime during vent hood operation. The “indicator” light should be on when the fan is running.

To turn fan OFF:

Move the “fan” switch to “0” or close the glass shelf. The fan will shut off when glass shelf is about 2" (5.1 cm) from the closed position. When the glass shelf is opened, the fan will operate at the last settings.

To turn vent hood light ON:

Open the glass shelf about 1"

(2.5 cm). Move the “light” switch to the “1” position. The light will be on each time the glass shelf is opened. The light can be used for a night light by opening the glass shelf about 1" (2.5 cm).

To turn vent hood light OFF:

Move the “light” switch to the “0” position. Or close the glass shelf.

Accessories

available from your dealer

Note: Instructions are included with each kit.

Front trim kit – matches the front panel color to range or cooktop color.

For 30" (76.2 cm) model series

For 30" (76.2 cm) model series

KWVU205 & YKWVU205:

GZ7730 & YGZ7730:

Part No. 4360201 (white)

Part No. 4396067 (white)

Part No. 4360203 (black)

Part No. 4396066 (black)

Part No. 4392855

(biscuit)

Part No. 8171368 (biscuit)

For 36" (91.4 cm) model series

 

KWVU265 & YKWVU265: :

For 36" (91.4 cm) model series

Part No. 4360202

(white)

GZ7736 & YGZ7736: :

Part No. 4360204

(black)

Part No. 4396069 (white)

Part No. 4392856

(biscuit)

Part No. 4396068 (black)

 

 

Part No. 8171369 (biscuit)

Non-Vent (recirculating) Kit:

Part No. 883140 – fits all models

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Installation Instructions Use and Care Guide Metal snips Before you startVent Hood Must be Connected with Copper Wire only Product dimensionsElectrical requirements 30 76.2 cm model 8 20.3 cm 36 91.4 cm model 11 27.9 cmRoof venting Wall venting4 x 10 8.3 cm x 25 cm Vent system Maximum length = 26 ftNon-vented recirculating Kit, Part No must be used To wire through top wiring For the Kwvu and Ykwvu model series Adjustment screwsMounting bracket Screw FilterFor GZ or YGZ model series Use and Care InformationAccessories ONE-YEAR Full Warranty Vent System WarrantyRequesting Assistance or Service in U.S.A Requesting Assistance or Service in CanadaOur consultants provide assistance with Pages Étapes de l’installationPanneau avant personnalisé Information dutilisationNiveau Vis Volet de réglagePince à dénuder PhillipsAlimentation électrique Dimensions du produitDécharge à travers le toit Conduit de 8,3 x 25 cm 4 x 10 poDécharge dans la pièce recyclage à travers le soffite 27,3 cm Axe central Cales de bois10 3/4 po Ouverture àCouvercle de la boîte De connexion Opercules arrachables pour passage du câblageBride de Fond du Montage Placard HottePour modèles des séries Kwvu et Ykwvu Panneau avant personnaliséInformation d’utilisation et entretien 37,3 mm 15/32 po Tableau de Commande couvercle de plastiquePour modèles des séries GZ et YGZ Surface frontale du panneauAccessoires Garantie Complète DE UN AN Garantie du système de ventilationSuccursales de service direct Demande d’assistance ou de service au Canada’exception de l’indicatif régional Et l’indicatif régional 807 en Ontario

Slide-out Vent Hood specifications

The KitchenAid Slide-out Vent Hood offers an innovative solution to maintaining a clean and comfortable kitchen environment. Designed to seamlessly blend into cabinetry, this vent hood provides functionality without compromising aesthetics. Its slide-out feature allows for easy access and efficient ventilation whenever cooking activities heat up, and it can be conveniently tucked away when not in use, preserving the sleek lines of your kitchen design.

One of the main features of the KitchenAid Slide-out Vent Hood is its powerful ventilation system, which effectively captures smoke, steam, and odors, ensuring that your kitchen remains fresh and free from airborne particles. With multiple fan speeds, users can easily adjust the airflow according to their cooking needs. The high-performance blower efficiently moves air, making it suitable for various cooking methods, from gentle simmering to high-heat frying.

In addition to its robust ventilation, this slide-out vent hood is equipped with bright, energy-efficient LED lighting. These lights illuminate the cooking surface below, enhancing visibility and ensuring that every culinary task is well-lit. The LEDs are not only long-lasting but also consume less energy, helping to reduce electricity bills while providing excellent illumination.

The KitchenAid Slide-out Vent Hood features a stainless steel construction, which is not only durable but also adds a modern touch to any kitchen decor. Its easy-to-clean design means that maintenance doesn’t become a chore; simply wipe down the surfaces to keep it looking new.

Another significant characteristic of this vent hood is its integrated grease filters, which are designed to capture and collect grease and other particles effectively. These filters are dishwasher-safe, making them convenient to clean and maintain, allowing for a more hygienic cooking environment.

Moreover, the KitchenAid Slide-out Vent Hood integrates seamlessly with other KitchenAid appliances, creating a cohesive look and feel within your kitchen. With options for customizable sizes and configurations, it can fit perfectly into a variety of kitchen layouts.

In summary, the KitchenAid Slide-out Vent Hood combines style, power, and convenience, making it an essential appliance for any home chef. Its advanced features, modern design, and user-friendly technologies elevate the kitchen experience, ensuring that cooking remains a pleasure rather than a chore.
Top Page Image Contents