KitchenAid LI32NA/W10674120B Range Hood USE, Display, Light, Timer, Fan Speed

Page 12

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.

The hood controls are located on the center of the range hood.

A

D

C

B

A. LED lamp housings

 

C. Blower and light controls

B. Grease filter handle

 

D. Grease filter

Control Panel

A BCD E

A. Power decrease

C. Display

E. Timer

B. Power increase

D. Light

 

Display

Grease Filter Saturation Alarm

After 30 hours of fan function, the display will show “Clean Grease Filter” when the fan is active. When this icon shows in the display, the installed grease filters should be washed. See the “Range Hood Care” section.

To reset the grease filter saturation alarm, press and hold the Power Increase button for 5 seconds. The “Clean Grease Filter” icon will no longer be displayed.

Charcoal Filter Saturation Alarm

After 120 hours of fan function, the display will show “Replace Charcoal Filter” when the fan is active. When this icon shows in the display, the charcoal filters should be replaced. See the “Range Hood Care” section.

To reset the charcoal filter saturation alarm, press and hold the Power Decrease button for 5 seconds. The “Replace Charcoal Filter” icon will no longer be displayed.

Audible Signal Activation and Deactivation

The audible signals can be activated or deactivated by pressing the “Light” button for 5 seconds.

If the audible signal is activated, a tone will sound, and “Snd” symbol will appear in the display for 3 seconds.

If the audible signal is deactivated, the “Snd” symbol will appear on the display for 3 seconds.

Charcoal Filter (Recirculation Accessory) Inclusion and Exclusion

When the charcoal filter is in use (recirculating mode), press and hold the Power Decrease and Power Increase buttons at the same time for 5 seconds. “Able” will appear in the display for 3 seconds.

If the charcoal filter is not used (vented mode), press and hold the Power Decrease and Power Increase buttons at the same time for 5 seconds. “None” will appear in the display for 3 seconds.

When the charcoal filter has been excluded, the charcoal filter alarm is disabled.

The inclusion or exclusion of the charcoal filter must be selected while the lights and the fan motor are Off.

Heat Sensor

The control is equipped with a heat sensor that will turn on the blower to the highest speed if excessive heat occurs around the control area.

If the blower is On or Off, the blower will automatically set to the highest speed. “Auto” will appear in the display to indicate that the heat sensor has detected excessive heat.

When the blower is operating due to excessive heat detected by the heat sensor, the blower speed cannot be decreased.

When the temperature level on the hood drops to normal, the blower will return to its setting before the excessive heat was sensed.

Light

To operate the light:

1.Press the Light button to turn the lights on.

2.Press the Light button again to turn the lights off.

Timer

The timer can be set from 1 to 60 minutes. The default timer setting is 10 minutes.

To use the timer:

1.Press the Timer button to enter the timer mode. After

5 seconds the default time will be automatically selected.

2.Press the Power Decrease and Power Increase buttons while the display is flashing (5 seconds) to adjust to the desired time. Pressing the timer button again or waiting 5 seconds after selecting the desired time will start the timer countdown.

3.The timer can be canceled at any time by pressing the Timer button again.

NOTE: During the timer setup, the Power Decrease and Power Increase buttons are dedicated to the timer. After the timer starts, the Power Decrease and Power Increase buttons can be used for other functions.

Fan Speed

Power Increase/On

This button is used to turn the fan On or increase the fan speed.

The fan will turn On if the Power Increase button is pressed and the hood was Off.

An audible tone will sound when the fan reaches its highest speed.

12

Image 12
Contents Hotte DE Cuisinière Table of Contents Range Hood SafetyTable DES Matières Important Safety Instructions Installation Requirements Tools and PartsLocation Requirements Installation Clearances Cold Weather InstallationsVenting Requirements Makeup AirCalculating Vent System Length Cm Round Vent SystemExample vent system ¹⁄₄ x 10 8.3 cm x 25.4 cm Vent SystemInstallation Instructions Determine Wiring Hole LocationTo wire through top Electrical RequirementsInstall Vent System Install In-Line Smart Kit OptionalTo wire through wall To make a 4 x 10½ 10.2 cm x 26.7 cm rectangle in the wallInstall Range Hood Vent Connector InstallationTop Vent Connector Installation Rear Vent Connector InstallationInstall Range Hood to Cabinet Complete Installation Optional Power Cord Kit InstallationsMake Electrical Connection Timer Range Hood USEDisplay LightCleaning Range Hood CareSE133A Assistance or Service AccessoriesU.S.A CanadaKitchenaid Major Appliance Limited Warranty Http//kitchenaid.custhelp.comSécurité DE LA Hotte DE Cuisinière Votre sécurité et celle des autres est très importanteImportantes Instructions DE Sécurité Exigences D’INSTALLATION Exigences demplacementOutillage et pièces Installations pour régions à climat froid Exigences concernant lévacuationDistances de dégagement à respecter Air dappointCalcul de la longueur effective du circuit dévacuation Système dévacuation avec conduits circulaires de 6 15,2 cmExemple de circuit d’évacuation Système de décharge de 3¹⁄₄ x 10 8,3 cm x 25,4 cmInstructions Dinstallation Préparation de lemplacementDéterminer l’emplacement du trou de passage du câble Spécifications électriquesCm x 25,4 cm Évacuation par le mur Câblage à travers le sommet du placardPassage du câble à travers le mur Installation de la hotte Installation du conduit d’évacuationInstallation avec connecteur de conduit par le haut Installation avec connecteur de conduit par larrièreCouvercle du moteur Installation de la hotte dans le placard Raccordement électriqueAchever l’installation Utilisation DE LA HotteAffichage Éclairage MinuterieVitesse du ventilateur Entretien DE LA Hotte NettoyageSchéma DE Câblage Terre L1 NeuAssistance OU Service AccessoiresAu Canada Http W10674120B

LI32NA/W10674120B specifications

The KitchenAid LI32NA/W10674120B is an innovative and versatile addition to any contemporary kitchen. Designed with precision and efficiency in mind, this model encapsulates the quality and craftsmanship that KitchenAid is renowned for. One of the standout features of this appliance is its impressive dual cooling system, which ensures optimal temperature control and humidity management, preserving the freshness of food for extended periods.

Equipped with an energy-efficient inverter compressor, the LI32NA minimizes the fluctuations in temperature that can compromise food quality. This technology operates quietly, making it ideal for open-plan living spaces where sounds can travel. Additionally, this model includes a robust LED lighting system that illuminates every corner of the refrigerator, providing clear visibility to all stored items while also being energy-efficient.

The interior layout of the LI32NA/W10674120B is both practical and stylish, featuring adjustable glass shelves that allow for maximum flexibility in organizing food and beverages. The spacious design incorporates specialized compartments, including a crisper drawer for fruits and vegetables, ensuring they remain crisp and flavorful.

Moreover, this model boasts an advanced filtration system that helps eliminate unwanted odors and contaminants, enhancing the overall quality of the air in the refrigerator. The exterior is complemented by a sleek stainless-steel finish that not only adds a touch of elegance but is also easy to clean and resistant to fingerprints.

For those who appreciate technology, the LI32NA/W10674120B comes with smart connectivity options, enabling users to monitor and adjust settings remotely through a compatible mobile application. This feature ensures that you can manage your appliance even when you’re away from home.

Overall, the KitchenAid LI32NA/W10674120B is a perfect fusion of style, functionality, and cutting-edge technology. Its attention to detail and commitment to preserving food quality makes it an excellent choice for anyone looking to upgrade their kitchen. Whether you're a culinary enthusiast or simply seeking convenience, this refrigerator is designed to meet a variety of lifestyle needs, making meal preparation and food storage simpler and more enjoyable.