KitchenAid KERS308X manual Triple radiant surface element, Radiant surface element settings

Page 11

Setting Surface Controls

Triple radiant surface element

To operate a triple radiant element:

1.Place correctly sized cookware on triple radiant surface element.

2.Press the On/Off keypad on the Electronic Surface Element control until tone sounds. If no temperature setting is selected within 6 seconds of pressing the On/Off keypad the control will turn off.

3.Press the High/+ keypad to start at the Hi setting and then press Low/— to scroll down to desired heat setting, or press the Low/— keypad to start at the Lo setting and press High/+ to scroll up to the desired heat setting.

4.Press the Burner Size keypad to toggle between one (Fig. 1), two (Fig. 2) or three elements (Fig. 3).

5.When cooking is complete, press the On/Off keypad to turn the radiant surface element OFF before removing the cookware.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Heating with

 

Heating 2 of 3

 

Heating with all 3

inner (small)

 

portions

 

portions

element only

 

 

 

 

 

 

 

 

Fig. 1

 

Fig. 2

 

Fig. 3

 

 

Heated areas are shown darkened.

Radiant surface element settings

The size and type of utensil used, and the amount and type of food being cooked will influence the surface element power level setting needed for best cooking results.

The suggested settings found in Fig. 4 below are based on cooking with medium-weight aluminum pans with lids. Settings may vary when using other types of pans.

Suggested settings for single, dual and triple radiant surface elements table

Settings

Type of cooking

 

 

High (90 - HI)

Start most foods, bring water to a

 

boil, pan broiling

 

Medium high (60 - 85) Continue a rapid boil, fry, deep

 

fat fry

 

 

Medium (30 - 55)

Maintain a slow boil, thicken

 

sauces and gravies or

 

steam vegetables

 

 

Simmer (20 - 28)

Keep foods cooking, poach, stew

 

 

Low (LO - 18)

Keep warm, melt, simmer

 

 

 

Fig. 4

Important notes:

•A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

•For efficient cooking, turn OFF the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process.

•Each surface element provides a constant amount of heat at each setting. Refer to the Suggested radiant surface element settings table for suggested power level settings.

•Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking.

•Radiant elements have a limiter that allows the radiant heating element to cycle ON and OFF, even at the HI setting. This helps prevent damage to the ceramic smoothtop. Cycling at the HI setting is normal and will occur more often if the cookware is too small for the radiant element or if the cookware bottom is not flat.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Models/Modèles KERS308X W10336756A 316902702 Table of Contents Save these instructions for future reference Important Safety InstructionsRead all instructions before using this appliance DefinitionsImportant Instructions for Using Your Oven Important Safety NoticeImportant Instructions for Using Your Cooktop Before Setting Oven Controls To replace Removing and replacing the glide oven racks To removeImportant note Cookware material typesBefore Setting Surface Controls To operate a single radiant element Setting Surface ControlsSingle radiant surface elements Dual radiant surface elementImportant notes Radiant surface element settingsTriple radiant surface element To operate a triple radiant elementWarm Zone some models Setting Warm Zone controlMinimum & maximum Control settingsFeature Min. temp. /time Max. temp. /time Oven Control FunctionsSetting 12 or 24 hour display mode Setting Oven ControlsSetting Clock Setting TimerSetting Control Lock Changing oven temperature displaySetting silent or audible control mode To activate Bread Proof feature Setting BakeExample To set Bake with default oven temperature of 350F Example To set Bake for oven temperature of 425FWhen the programmed cook time runs out Setting Cook TimeSetting Delay Start Broil Convect Roast Convection FeaturesConvect Bake Convect BroilExample To set EasyConvect Meats EasyConvect Feature Meats and Baked GoodsProper meat probe placement Meat ProbeTo set meat probe Operating Oven Light Adjusting Oven TemperatureRestoring Default Settings Example To turn off the Sabbath feature Sabbath Feature for use on the Jewish Sabbath & HolidaysArranging warming drawer rack positions Setting Warming Drawer ControlsSetting Warming Drawer Warming DrawerWarming drawer recommended food settings Setting Warming Drawer ControlWarming drawer recommended settings To prepare for Self Clean Self CleanRead before starting Self Clean Setting Self CleanIf it becomes necessary to stop Self Clean when active Delayed Start Self CleanWhen Self Clean is finished Surface type Recommendation Care & CleaningCleaning recommendation table Cooktop cleaning Cooktop maintenanceDo not use the following on the cooktop General cleaningAluminum foil and utensils Replacing oven lightSpecial door care instructions Removing and replacing the lift-off oven doorTo remove oven door To replace oven doorProblem Solution Before You Call Solutions to common problemsBefore You Call Solutions to common problems Before You Call Solutions to common problems Canada Assistance or ServiceAccessories U.S.A

KERS308X specifications

The KitchenAid KERS308X is a high-performance electric range designed for home cooks who seek precision and versatility in their culinary adventures. This model exemplifies KitchenAid's commitment to quality, offering a blend of cutting-edge technology and user-friendly features that cater to various cooking styles.

One of the most notable features of the KERS308X is its powerful oven capacity. The appliance boasts a spacious 5.8 cubic feet of oven space, allowing users to cook multiple dishes simultaneously, whether it's a holiday feast or a special family gathering. The oven is equipped with a self-cleaning function, making maintenance a breeze.

In terms of cooking performance, the KERS308X includes a true convection system, which circulates hot air evenly throughout the oven. This technology ensures consistent cooking results and reduces the cooking time significantly, making it ideal for baking and roasting. The oven also offers a wide range of temperature settings, allowing for precise cooking of various recipes.

The range features a five-burner cooktop, providing ample space for multitasking on the stove. The burners vary in sizes, including a powerful 19,000 BTU burner that is perfect for quick boiling and frying, while the simmer burner is ideal for delicate sauces and soups. The cooktop surface is made from durable ceramic glass, which not only enhances the aesthetics of the kitchen but also simplifies cleanup.

Another highlight of the KERS308X is its advanced electronic controls, which offer intuitive functionality. The user-friendly interface allows for easy temperature adjustments and cooking mode selections. Additionally, the range is equipped with a temperature probe, enabling cooks to monitor the internal temperature of their dishes without opening the oven door, ensuring perfectly cooked meals every time.

The KitchenAid KERS308X is also designed with safety in mind, featuring a control lock that prevents unintended adjustments during cooking. Its stainless steel finish adds a modern touch, easily complementing any kitchen design. Overall, the KitchenAid KERS308X is a robust and stylish electric range that brings professional-quality cooking into the home, making it an excellent choice for both amateur and seasoned chefs alike.
Top Page Image Contents