KitchenAid W10246119C Electrical Requirements -CanadaOnly, If connecting to a 4-wire system

Page 6

Range Rating*

 

Specified Rating of

 

 

Power Supply Cord Kit

 

 

and Circuit Protection

 

 

 

120/240 Volts

120/208 Volts

Amps

 

 

 

8.8 - 16.5 KW

7.8 - 12.5 KW

40 or 50**

16.6 - 22.5 KW

12.6 - 18.5 KW

50

 

 

 

*The NEC calculated load is less than the total connected load listed on the model/serial rating plate.

**If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp rated cord kits, use kits that specify use with a nominal 1³⁄₈" (34.93 mm) diameter connection opening.

■A circuit breaker is recommended.

■The range can be connected directly to the fused disconnect (or circuit breaker box) through flexible or nonmetallic sheathed, copper or aluminum cable. See the “Electrical Connection” section.

■Allow 2 to 3 ft (61.0 cm to 91.4 cm) of slack in the line so that the range can be moved if servicing is ever necessary.

■A UL listed conduit connector must be provided at each end of the power supply cable (at the range and at the junction box).

■Wire sizes and connections must conform with the rating of the range (40 amps).

■The wiring diagram is located on the underside of the storage drawer or below the warming drawer in a clear plastic bag.

If connecting to a 4-wire system:

This range is manufactured with the ground connected to the cabinet. The ground must be revised so the green ground wire of the 4-wire power supply cord is connected to the cabinet. See the “Electrical Connection” section.

Grounding through the neutral conductor is prohibited for new branch-circuit installations (1996 NEC); mobile homes; and recreational vehicles, or an area where local codes prohibit grounding through the neutral conductor.

When a 4-wire receptacle of NEMA Type 14-50R is used, a matching UL listed, 4-wire, 250-volt, 40-amp, range power supply cord (pigtail) must be used. This cord contains 4 copper conductors with ring terminals or open-end spade terminals with upturned ends, terminating in a NEMA Type 14-50P plug on the supply end.

The fourth (grounding) conductor must be identified by a green or green/yellow cover and the neutral conductor by a white cover. Cord should be Type SRD or SRDT with a UL listed strain relief and be at least 4 ft (1.22 m) long.

4-wire receptacle (14-50R)

The minimum conductor sized for the copper 4-wire power cord are:

40-amp circuit

2 No.-8 conductors

1No.-10 white neutral

1No.-8 green grounding

If connecting to a 3-wire system:

Local codes may permit the use of a UL listed, 3-wire,

250 volt, 40-amp range power supply cord (pigtail). This cord contains 3 copper conductors with ring terminals or open-end spade terminals with upturned ends, terminating in a NEMA Type 10-50P plug on the supply end. Connectors on the appliance end must be provided at the point the power supply cord enters the appliance. This uses a 3-wire receptacle of NEMA Type 10-50R.

3-wire receptacle (10-50R)

Electrical Requirements -CanadaOnly

WARNING

Electrical Shock Hazard

Electrically ground range.

Failure to do so can result in death, fire, or electrical shock.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge are in accordance with local codes.

Be sure that the electrical connection and wire size are adequate and in conformance with CSA Standard C22.1, Canadian Electrical Code, Part 1 - latest edition, and all local codes and ordinances.

A copy of the above code standards can be obtained from:

Canadian Standards Association

178 Rexdale Blvd.

Toronto, ON M9W 1R3 CANADA

■Check with a qualified electrical installer if you are not sure the range is properly grounded.

Range Rating*

 

Specified Rating of

 

 

Power Supply Cord Kit

 

 

and Circuit Protection

 

 

 

120/240 Volts

120/208 Volts

Amps

 

 

 

8.8 - 16.5 KW

7.8 - 12.5 KW

40 or 50

16.6 - 22.5 KW

12.6 - 18.5 KW

50

 

 

 

*The NEC calculated load is less than the total connected load listed on the model/serial rating plate.

■A time-delay fuse or circuit breaker is recommended.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Table of Contents/Table des matières W10246119CRange Safety Table DES MatièresInstallation Requirements ToolsandPartsLocation Requirements Mobile home installations require Mobile Home Additional Installation RequirementsProduct Dimensions Freestanding Range Slide-in RangeCabinet Dimensions Electrical Requirements U.S.A.OnlyElectrical Connection Local codes may permit the use of a UL listed, 3-wire If connecting to a 4-wire systemIf connecting to a 3-wire system Electrical Requirements -CanadaOnlyUnpack Range Installation InstructionsCountertopPreparation Measurefor Proper Height Slide-In RangesAdjust LevelingLegs Install Anti-TipBracketFreestanding Ranges Style 1 Power supply cord strain relief Power Supply CordDirect Wire Electrical Connection -U.S.A.OnlyDisconnect or Direct wire Circuit breaker Box Tighten strain relief screw against the power supply cordStyle 2 Direct wire strain relief Assemble a UL listed strain relief in the openingMetal ground strap Discard Ground-link screw Wire connection Power Supply CordHex nut Green ground wire Ground-link screw Line 2 red Line 1 blackBare green ground wire Direct Wire Installation Copper or Aluminum WireWire Connection Direct Wire Hex nutBare Wire Torque Specifications Wire Awg TorqueGauge copper Lbs-in .8 N-m Gauge aluminum Lbs-in .0 N-m Level Range Complete InstallationVerify Anti-Tip BracketLocation Movingthe RangeFor power supply cord-connected ranges For direct-wired rangesOutillage et pièces Exigences DinstallationSécurité DE LA Cuisinière Outillage nécessairePlanchette de remplissage arrière facultative Exigences demplacementPièces nécessaires Lors de l’utilisation d’un cordon d’alimentation électriqueDimensions du produit Cuisinière autoportante Cuisinière coulissanteDimensions du placard Cuisinière coulissanteLargeur min. de louverture 30 76,2 cm Préparationduplandetravail Instructions DinstallationSpécifications électriques Déballage dela cuisinièreAjuster les pieds de nivellement Installation dela brideantibasculementMesurespourunehauteurappropriée Cuisinières coulissantesVérification de lemplacement delabride Antibasculement Fixer le gabarit avec du ruban adhésifAcheverl’installation Réglage delaplomb de lacuisinièreSi la cuisinière ne fonctionne pas, contrôler ce qui suit Déplacement delacuisinière Cuisinières alimentées par cordon dalimentation

W10246119C specifications

The KitchenAid W10246119C is a versatile and essential kitchen appliance designed to enhance culinary experiences. This model focuses on providing efficiency and convenience for both amateur cooks and seasoned chefs.

One of its standout features is its powerful motor, which delivers optimum performance across a wide range of tasks. This motor is designed for durability and longevity, ensuring that users can rely on it for years to come. Coupled with a variety of attachments, the W10246119C allows users to tackle everything from mixing and blending to kneading and whipping, making it an invaluable addition to any kitchen.

The appliance typically incorporates several speed settings, allowing for precise control over mixing. This feature is crucial for achieving the perfect texture when preparing ingredients, be it for baking or cooking. Whether you need a slow stir for delicate mixtures or high-speed whipping for cream and egg whites, the W10246119C offers the flexibility required.

Technologically, the KitchenAid W10246119C often includes a user-friendly interface, featuring simple controls that make operation straightforward. The design is elegant, usually available in various colors to complement any kitchen décor. Additionally, its compact build ensures that it can fit comfortably on any countertop without taking up excessive space.

Another noteworthy characteristic is the appliance’s ease of cleaning. Many components are dishwasher-safe, simplifying the post-cooking cleanup process. The robust construction of the attachments also means they are built to withstand regular use, ensuring that the appliance remains a staple in the kitchen.

Furthermore, this model is often equipped with safety features, such as a locking mechanism, to prevent accidental operation. This is particularly beneficial when handling large quantities of ingredients or when using higher speeds.

In conclusion, the KitchenAid W10246119C combines power, versatility, and ease of use, making it an excellent tool for anyone looking to elevate their culinary skills. With its robust motor, multiple speed options, and range of attachments, it has become a trusted appliance in kitchens around the world, promising consistent results and effortless operation. Whether you are preparing a holiday feast or a simple weeknight dinner, the W10246119C stands ready to assist in creating delicious meals.
Top Page Image Contents