Denon AVR-5800 After starting playback, Example Stereo, Adjusting the sound quality tone

Page 34

3

Select the play mode.

Example: Stereo

STEREO

 

(Main unit)

(Remote control unit)

 

 

4

Start playback on the selected component.

• For operating instructions,

refer to the component’s

Input mode display

• In the AUTO mode

INPUT MODE

AUTO PCM DTS RF

• In the PCM mode

INPUT MODE

AUTO PCM DTS RF

• In the DTS mode

INPUT MODE

AUTO PCM DTS RF

One of these lights, depending on the input signal.

ANALOG DIGITAL

DIGITAL

DIGITAL

 

manual.

 

5

Adjust the volume.

MASTER VOLUME

• When switched to RF in the VDP RF or AUTO mode

INPUT MODE

 

 

AUTO PCM

DTS

RF

DIGITAL

 

 

 

• In the ANALOG mode

INPUT MODE

AUTO PCM DTS RF

ANALOG

The volume level is

(Main unit)

(Remote control unit)

displayed on the

 

 

master volume level

 

 

display.

 

 

Input signal display

• DOLBY DIGITAL

One of these lights, depending on the input signal.

The volume can be adjusted within the range of –60 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 25 or page 42, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is “18 dB

— (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “AUTO” or “DTS”.

NOTE:

•The digital input indicator will light (green) when playing CD- ROMs containing data other than audio signals, but no sound will be heard.

INPUTSIGNAL

 

LOCK DIGITAL

PRO LOGIC

• DTS

INPUTSIGNAL

LOCK DIGITAL

• PCM

INPUTSIGNAL

LOCK DIGITAL AL24

The AL24 indicator lights when the PURE DIRECT, DIRECT or STEREO mode is selected in the digital input mode.

The LOCK LED lights when digital signals are being input properly. If the LED does not light, check whether the digital input component setup (page 28) and connections are correct and whether the component’s power is turned on.

After starting playback

[1]Adjusting the sound quality (tone)

The tone control function will not work in the Direct or Home THX Cinema mode.

1

Press the MODE SELECT button and select

MODE

TONE.

SELECT

 

The mode switches as follows each time

 

 

the MODE SELECT button is pressed:

 

 

 

(Main unit)

 

Only displayed when the TUNER input is

 

 

selected.

 

2

Select BASS/TREBLE with the

FUNCTION

FUNCTION knob.

 

(Main unit)

4 1 2 3

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents AVR-5800 Safety Precautions Safety Instructions Table of Contents Before UsingFeatures Connecting the audio components ConnectionsConnecting video components TV/DBSConnecting a video component equipped with S-Video jacks Precaution when using S-jacksConnecting a DVD player DVD in jacks Connecting the antenna terminals FM antenna adapter assemblyConnecting the external input EXT. in jacks Connecting the Multi Source jacksSpeaker system connections Connecting the speaker cordsSpeaker Impedance Connections Surround Speaker Systems aPart Names and Functions Front PanelRemote control unit Setting UP the System MuteSpeaker system layout Surround speaker selector functionBefore setting up the system 6, 7Setting the type of speakers Setting the Subwoofer mode ParametersSubwoofer mode Setting the Surround Back channelAssignment of low frequency signal range THX surround EX/DTS ES Auto Flag Detect Mode Afdm settingSetting the delay time PreparationsSetting the Multi Zone Control Setting the multi-zone 1 levelVariable 40 dB, 0 dBSetting the channel level Channel Level screen reappears Subwoofer peak limit level setting Setting the Digital In Assignment Setting the on-screen display OSD Auto tuner presetsAfter completing system setup On-screen display signalsRemote Control Unit Using the remote control unitOperation Operating the remote control unitBefore operating Playing the input source Input mode selection functionExample CD After starting playback Adjusting the sound quality toneExample Stereo Checking the currently playing program source, etc Listening over headphonesSwitching the surround speakers Turning the sound off temporarily mutingMulti-source recording/playback Playing one source while recording another REC OUT modeRecording Dolby Digital and DTS multichannel sources Press the M-ZONE 1 button Playback using the external input EXT. in jacks PRE OUT EFFECT/SB left and right jacksStereo mode Pure Direct modeDirect mode Playing audio sources CDs and DVDsMulti-zone playback using the Multi Zone 1 terminals Multi-source and multi-zone playbackMulti-zone playback using the Multi Zone 2 terminals Remote Control UnitSurround Before playing with the surround functionRemote Control Unit Fader functionPlaying modes for different sources THX Surround EX / Home THX Cinema mode Surround parameters q Afdm Auto Flag Detect ModeSet the input mode to Auto Select the Surround modeDolby Surround Pro Logic mode DTS Neo6 modeDenon Original Surround Modes Surround modes and their featuresPersonal Memory Plus Select the surround mode for the input channel DSP surround simulationTone control setting Surround parameters e Surround modes and parametersManual tuning Auto tuningListening to the Radio Remote control unit Preset memoryChecking the preset stations Main unitLast Function Memory Recalling preset stationsInitialization of the Microprocessor Troubleshooting Optimum surround sound for different sources Types of multi-channel signalsAdditional Information Movie audioSurround back speakers Number of surround back speakersSpeaker setting examples When using different surround speakers for movies and music When not using surround back speakers2Dolby Digital and Dolby Pro Logic SurroundDolby Surround Dolby Digital Dolby Surround AC-3 Dolby Digital compatible media and playback methodsDolby Pro Logic compatible media and playback methods DTS Digital SurroundDolby Pro Logic DTS compatible media and playback methodsDTS-ES Extended Surround TM Home THX Cinema surround mode THX Surround EXTHX Surround modes and parameters Specifications Audio section14-14, Akasaka 4-CHOME, MINATO-KU, Tokyo 107-8011, Japan
Top Page Image Contents