Denon AVR-5800 operating instructions Playback using the external input EXT. in jacks

Playback using the external input (EXT. IN) jacks

1	Set the external input	EXT. IN
	(EXT. IN) mode.
	Press the EXT. IN (on the
	EXT. IN button on the remote
	control unit) to switch the
	external input.	(Main unit)	(Remote control unit)
	The playback switches as shown below each time the button
	is pressed.
	EXT. IN-1	EXT. IN-2
	Once this is selected, the input signals connected to the
	FRONT-L , FRONT-R, CENTER, SURR.-L (surround left) and
	SURR.-R (surround right) channels of the EXT. IN jacks are
	output directly to the front (left and right), center and surround
	(left and right) speaker systems as well as the pre-out jacks
	without passing through the surround circuitry.
	In addition, the signal input to the SW (subwoofer) jack is
	output to the PRE OUT SW (subwoofer) jack.
	When EXT. IN is selected, the input signals connected to
	the EL (effect left) and ER (effect right) jacks are output to
	the PRE OUT EFFECT/SB (left and right) jacks.
2	Cancelling the external input mode
	To cancel the external input (EXT. IN) setting, press the INPUT
	MODE or ANALOG button to switch to the desired input

mode.

INPUTANALOG

MODE

2	1
2
2
1

(Main unit) (Remote control unit)

•When the input mode is set to the external input (EXT. IN), the play mode (PURE DIRECT, DIRECT, STEREO, DOLBY/DTS SURROUND, HOME THX CINEMA, WIDE SCREEN, 5CH/7CH STEREO or DSP SIMULATION) cannot be set.

NOTES:

•In play modes other than the external input mode, the signals connected to these jacks cannot be played. In addition, signals cannot be output from channels not connected to the input jacks.

•The external input mode can be set for any input source. To watch video while listening to sound, select the input source to which the video signal is connected, then set this mode.

38