Denon AVR-5800 operating instructions Specifications, Audio section

Page 66

17 SPECIFICATIONS

2Audio section

•Power amplifier Rated output:

(All properties shown are only for the power amplifier stage.)

Dynamic power:

Output terminals:

•Analog

Input sensitivity / input impedance: Frequency response:

S/N:

Distortion:

Rated output/maximum output:

•Digital

D/A output:

Digital input:

•Phono equalizer (PHONO input — REC OUT) Input sensitivity:

RIAA deviation: Signal-to-noise ratio:

Rated output / Maximum output: Distortion factor:

2Video section

•Standard video jacks

Input / output level and impedance: Frequency response:

•S-video jacks

Input / output level and impedance: Frequency response:

•Color component video terminal Input / output level and impedance:

Frequency response:

2Tuner section

Receiving Range:

Usable Sensitivity:

50 dB Quieting Sensitivity:

Signal to Noise Ratio (IHF-A):

Total Harmonic Distortion (at 1 kHz):

2General

Power supply:

Power consumption:

Maximum external dimensions:

Mass:

2Remote control unit (RC-8000) Batteries:

External dimensions: Mass:

Stereo (2ch driven)

170 W + 170 W (8 Ω /ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.) 200 W + 200 W (6 Ω /ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.)

190 W x 2 ch

(8 Ω /ohms)

310 W x 2 ch

(4 Ω /ohms)

390 W x 2 ch

(2 Ω /ohms)

Front/Center:

 

6 ~ 16 Ω /ohms

Surround:

A or B

6 ~ 16 Ω /ohms

 

A + B

8 ~ 16 Ω /ohms

200 mV / 47 kΩ /kohms

10 Hz ~ 100 kHz: +0, –3 dB (DIRECT mode) 105 dB (DIRECT mode)

0.005% (20 Hz ~ 20 kHz) (DIRECT mode)

1.2 V / 8 V

Rated output — 2 V (at 0 dB playback)

Total harmonic distortion — 0.003% (1 kHz, at 0 dB)

S/N ratio — 115 dB

Dynamic range — 112 dB

Format — Digital audio interface

2.5 mV

±1 dB (20 Hz to 20 kHz)

74 dB (A weighting, with 5 mV input)

150 mV / 8 V

0.03% (1 kHz, 3 V)

1 Vp-p, 75 Ω /ohms

5 Hz ~ 10 MHz — +0, –3 dB

Y (brightness) signal

—

1 Vp-p, 75 Ω /ohms

 

C (color) signal — 0.286 Vp-p, 75 Ω /ohms

 

5 Hz ~ 10 MHz — +0, –3 dB

 

Y (brightness) signal

—

1 Vp-p, 75 Ω /ohms

 

Cb (blue) signal —

0.7 Vp-p, 75 Ω /ohms

 

Cr (red) signal — 0.7Vp-p, 75 Ω /ohms

 

DC ~ 50 MHz — +0, –3 dB

 

[FM] (note: µV at 75 Ω /ohms, 0 dBf = 1 x 10–15 W)

[AM]

87.5 MHz ~ 107.9 MHz

 

520 kHz ~ 1710 kHz

1.0 µV (11.2 dBf)

 

 

18 µV

MONO

1.6 µV (15.3 dBf)

 

STEREO

23 µV (38.5 dBf)

 

MONO

80 dB

 

 

50 dB

STEREO

75 dB

 

 

 

MONO

0.15%

 

 

 

STEREO

0.3%

 

 

 

AC 120 V, 60 Hz 12 A

434 (W) x 216 (H) x 486 (D) mm (17-3/32” x 8-1/2” x 19-9/64”) 28.0 kg (61 lbs 11.7 oz)

LR6/AA Type (four batteries)

96 (W) x 38 (H) x 168.5 (D) mm (3-25/32” x 1-1/2” x 6-41/64”) 242 g (Approx. 8.5 oz) (not including batteries)

* For purposes of improvement, specifications and design are subject to change without notice.

66

Page 65 Page 67
Image 66
Page 65 Page 67
Contents AVR-5800 Safety Precautions Safety Instructions Table of Contents Before UsingFeatures Connecting the audio components ConnectionsConnecting video components TV/DBSConnecting a video component equipped with S-Video jacks Precaution when using S-jacksConnecting a DVD player DVD in jacks Connecting the antenna terminals FM antenna adapter assemblyConnecting the external input EXT. in jacks Connecting the Multi Source jacksConnecting the speaker cords Speaker system connectionsSpeaker Impedance Connections Surround Speaker Systems aPart Names and Functions Front PanelRemote control unit Setting UP the System MuteSpeaker system layout Surround speaker selector functionBefore setting up the system 6, 7Setting the type of speakers Setting the Subwoofer mode ParametersSubwoofer mode Setting the Surround Back channelAssignment of low frequency signal range THX surround EX/DTS ES Auto Flag Detect Mode Afdm settingSetting the delay time PreparationsSetting the Multi Zone Control Setting the multi-zone 1 levelVariable 40 dB, 0 dBSetting the channel level Channel Level screen reappears Subwoofer peak limit level setting Setting the Digital In Assignment Setting the on-screen display OSD Auto tuner presetsAfter completing system setup On-screen display signalsRemote Control Unit Using the remote control unitOperating the remote control unit OperationBefore operating Input mode selection function Playing the input sourceExample CD Adjusting the sound quality tone After starting playbackExample Stereo Checking the currently playing program source, etc Listening over headphonesSwitching the surround speakers Turning the sound off temporarily mutingPlaying one source while recording another REC OUT mode Multi-source recording/playbackRecording Dolby Digital and DTS multichannel sources Press the M-ZONE 1 button Playback using the external input EXT. in jacks PRE OUT EFFECT/SB left and right jacksStereo mode Pure Direct modeDirect mode Playing audio sources CDs and DVDsMulti-zone playback using the Multi Zone 1 terminals Multi-source and multi-zone playbackMulti-zone playback using the Multi Zone 2 terminals Remote Control UnitSurround Before playing with the surround functionRemote Control Unit Fader functionPlaying modes for different sources THX Surround EX / Home THX Cinema mode Surround parameters q Afdm Auto Flag Detect ModeSet the input mode to Auto Select the Surround modeDolby Surround Pro Logic mode DTS Neo6 modeSurround modes and their features Denon Original Surround ModesPersonal Memory Plus Select the surround mode for the input channel DSP surround simulationTone control setting Surround parameters e Surround modes and parametersAuto tuning Manual tuningListening to the Radio Remote control unit Preset memoryChecking the preset stations Main unitRecalling preset stations Last Function MemoryInitialization of the Microprocessor Troubleshooting Optimum surround sound for different sources Types of multi-channel signalsAdditional Information Movie audioSurround back speakers Number of surround back speakersSpeaker setting examples When using different surround speakers for movies and music When not using surround back speakers2Dolby Digital and Dolby Pro Logic SurroundDolby Surround Dolby Digital Dolby Surround AC-3 Dolby Digital compatible media and playback methodsDolby Pro Logic compatible media and playback methods DTS Digital SurroundDolby Pro Logic DTS compatible media and playback methodsDTS-ES Extended Surround TM Home THX Cinema surround mode THX Surround EXTHX Surround modes and parameters Specifications Audio section14-14, Akasaka 4-CHOME, MINATO-KU, Tokyo 107-8011, Japan
Top Page Image Contents