Hotpoint DX 1032 CX S manual If something Goes wrong, There MAY be Nothing Wrong

If something

goes wrong...

Before calling a Service Engineer, please check through the following lists.

THERE MAY BE NOTHING WRONG.								GB
	Problem			Check
	Slight odour or
	small amount of
	smoke when grill /			This is normal and should cease after a short period.
	oven used for first
	time
				If you find that the timer display is blank, then it is likely that there is no electricity supply to
				your oven. Check:
	Nothing works			(i) That the main cooker wall is switched on
				(ii) Other appliances, to see if you have had a power cut
				(iii) The main circuit breaker for the property
				Operating the cooker under the following conditions may cause a safety device to operate:
	Top oven, grill and			(a) Grilling with the door closed - Always grill with the door fully open
	main oven do not			(b) Grilling for an excessively long period at maximum setting - see Grilling guide.
	work.			Switch off appliance and allow to cool for approx 30 mins.
				Switch the cooker back on and check that the Grill / Top oven is now operating.
	Grill keeps turning			When the Grill control is operating at less than its maximum setting, the Grill will cycle on
	on and off			and off, this is normal and not a fault.
	Timer Display is			The power supply to your oven has possibly been interrupted, but has now come back on
				again. Reset the timer to the correct time and "Manual" operation using the instructions given
	flashing '0.00		'
				in the timer section of the book.
	Oven temperatures			Check temperature and shelf positions are as recommended in the Oven Temperature
				Charts.
	too high or low
				It may be necessary to increase or decrease the recommended temperature slightly to suit
				your taste.
	Oven does not			Check:
				(a)	Temperature and shelf positions are as recommended in the Oven Temperature Charts.
	cook evenly
				(b)	Oven utensils being used allow sufficient air flow around them.
	The oven is not
	working and			Your appliance has developed a fault which will require assistance from our service
	showing F01 to F68			department.
	code in the display
		Problem				Possible causeS	olution
		The “Clock button” and the				The appliance has just been	Set the clock.
		digits on the display flash.				connected to the electricity
						mains or there has been a blackou
		A programmed cooking mode				There has been a blackout.R	eprogram the cooking mode.
		does not start.
		Only the high luminosity				The appliance is in standby mode	Press any button to exit
		“Clock button” is lit.					standby mode.
		An automatic mode has been				The temperature inside the oven	Wait for the oven to cool down.
		selected. “Hot” appears on the				is higher than the suggested value
		display and cooking does not start				for the selected mode.
		Fan-assisted cooking has been				Positions 1 and 5: the direct	We recommend switching
		selected and the food looks burnt.				heat could cause	dripping pan positions halfway
						temperature-sensitive	through cooking.
						foods to burn.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

25