Hotpoint CH 10755 GF S, CH 10756 GF S, CH 10750 GF S GB Introduction, Installation

Page 4

GB Introduction

!Before placing your new appliance into operation please read these operating instructions carefully. It contains important information concerning the safe installation and operation of the appliance.

!Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved.

!The appliance must be installed by a qualified professional in accordance with the instructions provided.

!Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply.

The cookers have the following technical specifications:

Category: I2H (GB)

This appliance must be installed in accordance with the regulations in force and only used in a well ventilated space. The data badge is fitted on the rear panel. The model/serial number can also be found on a badge located below the left-hand oven door beneath the door seal.

Read these instructions before installing or using the appliance and retain them for future reference.

These instructions are only valid for the countries whose symbols appear in the manual and on the serial number plate.

To help you make the best use of your cooker, PLEASE READ THIS BOOKLET CAREFULLY.

Your new cooker is guaranteed and will give lasting service. The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions. The cooker is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.

When first using the cooker ensure that the room is well ventilated (e.g. open a window or use an extractor fan) and that persons who may be sensitive to the odour avoid any fumes. It is suggested that any pets be removed from the room until the smell has ceased. This odour is due to any temporary finish and also any moisture absorbed by the insulation.

Our policy is one of continual improvement in design and development, therefore strict accuracy of illustrations and descriptions cannot be guaranteed.

MODEL NUMBERS

CH10750GF S, CH10755GF S, CH10756GF S Category I2H (GB)

This model is set to burn NATURAL GAS (G20) at 20 mbar

GAS SAFETY (INSTALLATION & USE) REGULATIONS It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the above regulations. It is in your interest and that of safety to ensure compliance with the law.

In the UK, CORGI registered installers work to safe standards of practice.

The cooker must also be installed in accordance with Current national legislation.

Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution.

LOCATION

The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or shower. The cooker must not be installed in a bed-sitting room of less than 20m3.

PROVISION FOR VENTILATION

The room containing the cooker should have an air supply in accordance with Current national legislation.

The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the room has a volume between 5 and 10m3, it will require an air vent of 50cm2 effective area unless it has a door which opens directly to outside. If the room has a volume of less than 5m3, it will require an air vent of 100cm2 effective area. If there are other fuel burning appliances in the same room, in accordance with Current national legislation should be consulted to determine air vent requirements.

DIMENSIONS

Height: 900 - 915 mm

Widht: 1000 mm

Depth: 600 mm (excluding door handles)

GENERAL

 

Gas connection

Rp ½ (½” BSP female)

Pressure test point

Hotplate burner injector

Gas rate adjustment

None

Aeration adjustment

None

Electrical connection

Flexible cord fitted with a 13A plug

 

230-240V~ 50Hz. 3A fuse.

Installation

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data badge which is fitted on the back panel.

This appliance is not designed to be connected to a combustion products evacuation device. It must be installed and connected in accordance with current installation regulations. particular attention should be given to the relevant requirements regarding ventilation.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

4

Image 4
Contents Operating Instructions CH 10750 GF S CH 10755 GF S CH 10756 GF SGB Warnings Overall view Description of the applianceControl panel Installation GB IntroductionSpace for fixing Cooker hoodsNatural Gas BurnerLevelling Installation & Operational ChecksElectrical connection For your safety AlwaysIf a Moulded Plug is Fitted AlwaysOven timer operation NeverAutomatic cooking NeverSetting the time of day Timer function buttonsSetting the minute minder Clockface SymbolsAuto cooking programmes To cancel the audible tonePress the Minute Minder button Other notes on timer operation Models with Hob Gas Burner Safety Devices to Prevent LeaksHotplate To USE the HotplateSafety requirements for deep fat frying How to deal with a fat fireGriddle Some recipe ideas for your griddleUsing the grill pan kit GrillTo USE the Grill Do notOvens Oven cooking chart FishMeat and Poultry VegetablesYeast Mixtures CAKES, Pastries & BiscuitsMiscellaneous ‘slow cook’ setting Care and cleaningCooker Finish Cleaning Method Disposal of your productDisposal of old electrical appliances Be followed for the disposal of your productProblem Check Something wrong with your cookerGB After Sales Service Hotpoint ServiceParts and Accessories Essential Contact InformationYear Parts Guarantee Extended GuaranteesFree Helpdesk Service 08448 24 24 24 Republic of Ireland 01 230Page Page 195104110.01