Advanced Programming Options (continued)
Steam Wetness or Steam Pump Rate
The steam pump rate of this espresso machine has been
To do this you need to follow the instructions below:
1.Insert the power cord into a
2.Press and hold down the ‘HOT WATER’ button for 3 seconds.
3.While still holding down the ‘HOT WATER’ button briefly press the ‘POWER’ button and release.
4.Release the ‘HOT WATER’ button.
Note: This activates the programmability of the steam pump rate and to signal this the machine will output the current setting with a sequence of beeps. See chart below to determine what setting your machine is programmed to.
Beep Sequence | Setting |
3 short beeps | + 3 |
2 short beeps | + 2 |
1 short beep | + 1 |
1 short and 1 long beep | Factory Setting |
1 long beep | - 1 |
2 long beeps | - 2 |
3 long beeps | - 3 |
Note: The lights behind the 'COFFEE' and 'STEAM' buttons will start flashing.
Down
5.Within 30 seconds press and release one of the flashing buttons depending on the required flow rate adjustment;
Up (+) a setting : Press 'STEAM'
Down
Note: When you have selected a new pump rate setting the machine will sound a sequence of beeps to indicate the new pump rate setting.
6.To save your settings press and hold down the 'HOT WATER' button for 3 seconds. A single long beep will sound to indicate your settings have been saved.
Note: The espresso machine will then automatically power on and begin heating up.
Note: The machine will stay in programming mode for up to 30 seconds. If you do not select a new pump rate setting within 30 seconds the program will automatically return to the Factory Setting and the espresso machine will then power on and begin heating up.
28