Sunbeam EM6200 Care and Cleaning, Drip tray and grill, Group head, group handle & filter baskets

Page 28

Care and Cleaning

The coffee making process involves extracting oils out of coffee grinds to make espresso coffee. Deposits of these oils build up over time and affect the taste of the coffee and operation of the espresso machine.

Regular cleaning to remove these oils is essential and will maintain the quality of the coffee the espresso machine produces and result in less maintenance being required. This is easy to do by following a few quick and easy cleaning steps after each coffee making session;

  Cycle water through the group head,   Purge steam through the steam wand,

  Wipe the steam wand clean with a damp cloth immediately after use,

  Remove the filter basket from the group handle and clean away any old coffee oils, and

  Empty the drip tray and rinse.

Important: Never wash any of the espresso machine parts or accessories in the dishwasher.

Drip tray and grill

Remove the drip tray and grill at regular intervals to empty (35) (36). Clean with water and a little non-abrasive washing up liquid, rinse and dry.

Over time it is normal for the inside of the drip tray to be stained by the oils in the coffee.

Group head, group handle & filter baskets

The filter baskets and group handle should be rinsed with warm water after each use and then dried thoroughly.

To clean the group head of any old coffee grinds cycle water through and wipe the group head and around the inside rim with a damp cloth.

Should the holes in the filter baskets become clogged with coffee grinds use a fine bristled brush to remove them. Also you can use the cleaning pin which is supplied with the espresso machine. The cleaning tool is located behind the water reservoir and drip tray (37). The cleaning tool has two pins at either end. One is the thinner and shorter of the two and is for cleaning out the hole in the filter basket. Insert the cleaning pin into the single hole in the base of the filter (38).

Group head rubber seal

The group head seal is located on the underside of the group head and creates a seal against the group handle during the espresso pour.

Note: During long periods of non-use we recommend that the group handle not be left attached to the group head as this will reduce the life of the seal.

Over time the seal will lose its elasticity and require replacement, depending on use usually every 12 months. Signs that the seal is deteriorating are when the group handle cannot create the necessary seal and steam and/or water escapes from around the group head during the espresso pour. Another sign may be when the group handle locks off to the right rather than the front.

Note: Contact Sunbeam on 1300 881 861 should you think that the group head seal needs replacing. Please do not attempt to change the seal without first consulting Sunbeam.

26

Image 28
Contents Espresso Vita Page Contents Important instructions retain for future useSunbeam’s Safety Precautions Safety Precautions for Your Sunbeam Espresso MachineAbout espresso coffee Features of your Sunbeam Espresso Vita Water level indicatorWarming plate Push button control panel600ml jug Cleaning tool Espresso gaugeProgrammable control panel Steam and hot water control dial 5L water reservoirThermoblock Heating System Bar PumpCrema System Features of your Sunbeam Espresso Vita Optimum Pour Under Over ExtractedUsing the control panel PowerReady Mode ManualUsing the control panel Double EspressoProgramming the Single or Double pours SteamHot Water Reference guide to using your espresso machine Unit on Use. Ready Mode Warming the espresso cupsMaking the espresso Reference guide to using your espresso machinePlace group handle onto group head Texturing milk Press the Steam button to activate steam modeTurn off steam by turning dial clockwise Swing steam wand to the side of espresso machine Cleaning Resetting the Factory Settings Programming your espresso machineProgramming Single Espresso Programming Double EspressoProgramming your espresso machine Preparing your espresso machine before use Guide to the perfect espresso Preheat GlassesPreheat Group Handle and Filter Basket Dosing and TampingEco Mode and Standby Mode Guide to the perfect espressoPre-Infusion Caring for your Espresso MachineGuide to milk texturing Using the hot water function Guide to milk texturingEspresso Recipes 190mL cup Hot water to taste Single or double espressoEspresso Recipes Caffe LatteCare and Cleaning Drip tray and grillGroup head, group handle & filter baskets Group head rubber sealCup warming plate and exterior Care and CleaningSteam wand Descaling Descaling solutionDescaling the espresso machine Descaling Espresso Thermoblock Temperature Press and hold down the ‘MANUAL’ buttonPlease refer to the chart below Steam Thermoblock TemperaturePress and hold down the ‘HOT WATER/ STEAM’ button Steam Wetness or Steam Pump Rate Steam Pump Rate ProgrammingSteam thermoblock temperatures and the steam pump rate Factory ResetAdvanced Programming Options Trouble shooting guide Problem Possible cause What to doGroup handle No coffee runs throughTrouble shooting guide Coffee is too coldEspresso tastes burnt Uneven cup fillingLoad noise Australia Month Replacement GuaranteeNew Zealand Need help with your appliance?

EM6200 specifications

The Sunbeam EM6200 is a versatile and stylish espresso machine designed for coffee enthusiasts who value both performance and aesthetics. This compact unit combines advanced features with user-friendly operation, making it an ideal choice for home baristas and casual coffee drinkers alike.

One of the standout features of the Sunbeam EM6200 is its powerful 15-bar Italian pump, which ensures optimal pressure for extracting rich, flavorful espresso shots. This high pressure is crucial for producing a perfect crema, delivering a café-quality experience right in the comfort of your kitchen. The machine heats up quickly thanks to its stainless steel boiler, enabling users to brew in just a short time without sacrificing quality.

In terms of user interface, the EM6200 is equipped with a combination of manual controls and an easy-to-read LCD display. This allows users to select from various coffee options, adjust the coffee strength, and customize their brewing experience. The intuitive layout ensures that even beginners can enjoy a seamless brewing process.

The Sunbeam EM6200 also features a built-in steam wand for frothing milk. This allows users to create creamy lattes, cappuccinos, and macchiatos with ease. The steam wand is designed with a 360-degree rotation, providing flexibility in frothing techniques and simplifying the milk texturing process.

For coffee aficionados looking for flexibility, the EM6200 supports both ground coffee and E.S.E. pods. This versatility ensures that users can enjoy their favorite coffee varieties while also having the convenience of pre-packaged options. The machine comes with a removable drip tray and water reservoir, making cleanup and maintenance a breeze.

Additional attributes of the Sunbeam EM6200 include its sleek design, available in various finishes, which enhances any kitchen decor. The machine is also equipped with safety features such as an automatic shutdown, giving users peace of mind during use.

Overall, the Sunbeam EM6200 is a well-rounded espresso machine that combines modern technology with practical features. Its combination of functionality, ease of use, and elegant design makes it a popular choice for coffee lovers seeking to elevate their home brewing experience. Whether you are a novice or an experienced barista, the EM6200 is equipped to help you craft the perfect cup of coffee every time.