Sunbeam EM6200 Steam Thermoblock Temperature, Press and hold down the ‘HOT WATER/ STEAM’ button

Advanced programming options (continued)

Steam Thermoblock Temperature

The steam temperature of this espresso machine has been calibrated to deliver a powerful and dry steam for texturing milk. The temperature of the steam can be modified in increments of 2°C up and down should it be desired.

To do this you need to follow the instructions below:

1.Insert the power cord into a 230-240V AC power outlet and switch the power ‘ON’.

Note: Although the espresso machine is ON at the power outlet ensure that the actual espresso machine power is ‘OFF’. Therefore no lights will be illuminated on the espresso machine control panel.

2.Press and hold down the ‘HOT WATER/ STEAM’ button.

3.While still holding down the ‘HOT WATER/ STEAM’ button briefly press the ‘POWER’ button and release all buttons.

Note: This activates the programmability of the Steam Thermoblock Temperature and to signal this a series of beeps will follow and the ‘HOT WATER/STEAM’ button LED will light up. Additionally the ‘SINGLE’ and ‘DOUBLE’ button LEDS will start to flash.

Note: A series of beeps will indicate the current setting.

4.Press the ‘SINGLE’ button to decrease the steam temperature or to increase the steam temperature press the ‘DOUBLE’ button.

Please refer to the chart below.

Steam Temperature Programming

Setting	Beep Sequence
+3 (Factory Setting)	3	Short Beeps
+2	2	Short Beeps
+1	1	Short Beep

01 Short Beep and 1 Long Beep

-1	1	Long Beep
-2	2	Long Beeps
-3	3	Long Beeps

5.Once you have selected the desired temperature, press and hold the ‘HOT WATER/STEAM’ button to save the new setting. A single long beep will sound to indicate the new setting has been saved. The espresso machine will then turn on to ‘READY MODE’.

Remember: If you do not press the ‘HOT WATER/STEAM’ button within 30 seconds the program will return to the Factory Setting and the espresso machine will then power on and begin heating up.

31