Sunbeam EM2300 manual Functions of your Café Ristretto, Preparing an espresso

Functions of your Café Ristretto™

1. ESPRESSO FUNCTION

For best results, it is ideal to pre-heat your cups, filter handle and filter as follows:

•Insert the power cord into a 230-240V AC power outlet and turn the power on.

•Fill the water reservoir (1) (2), (3) (4) (5) with cold water and start the appliance (6).

•Put the filter handle and an empty filter in place (7) (8) (9), and place cups underneath the filter handle.

•As soon as the ‘Warm-Up’ light turns ‘Off’, this indicates that the Café Ristretto™ is ready to be used.

Tip: Remember that if the ‘Warm-Up’ light is ‘On’ it means the espresso machine is ‘Heating’. If the ‘Warm-Up’ light is ‘Off’ then you can start using the espresso machine.

•Press the button (11).

•When the cups are full of hot water, press

the button again to stop the water flow.

Note: Once the appliance has been on for a while, the coffee cups can be warmed by placing them upside down on the cup warming plate (12).

Preparing an espresso:

•Insert the power cord into a 230-240V AC power outlet and turn the power on.

•Fill the water reservoir (1) (2), (3) (4) (5) with cold water.

•Turn the Café Ristretto™ ‘On’ (6). The power light will illuminate red and an amber ‘Warm-Up’ light will turn ‘On’ indicating that your espresso machine is ‘On’ and ‘Heating’ to the required temperature.

•Pre-heat your coffee cups.

•Select the required filter (7) for 1 or 2 cups of coffee and place in the filter handle.

•Using the measuring spoon supplied, place one or two measures of ground coffee into the filter (13). With the other end of the measuring spoon, use the tamper to push (pack) down the coffee grinds (14). Do not apply too much pressure.

Important: Be sure not to over-fill the filter with too much coffee. Wipe around the edge of the filter to remove any coffee grinds (15).

•Place the filter handle on the machines brewing head. Position the handle so it points to the left, place the filter handle flat against the brewing head, then turn the handle towards the right (16) as far as it can go.

Note: Do not over tighten.

•Place 1 or 2 pre-heated cups below the pouring spouts.

•When the Café Ristretto™ is at the correct temperature the ‘Warm-Up’ light will turn ‘Off’.

Tip: Remember that if the ‘Warm-Up’ light is ‘On’ it means the espresso machine is ‘Heating’. If the ‘Warm-Up’ light is ‘Off’ then you can start using the espresso machine.

•To make an espresso press the button (11). Once the cups are filled to the

desired level, press the button again to stop the flow.

•Remove the filter handle and the filter by turning the filter handle to the left.

•To remove the used coffee grinds from the filter, simply turn the filter handle upside down in a bin and gently spoon out the used coffee grinds (18).

13