English
•Have any damaged or defective parts repaired or replaced by an authorized repair agent.
•Before use, check the power supply cord for signs of damage, aging and wear.
•Do not use the appliance if the power supply cord or mains plug is damaged or defective.
•If the supply cord is damaged, it must be replaced by the manufacturer or an authorized Black & Decker Service Centre in order to avoid a hazard.
•Never attempt to remove or replace any parts other than those specified in this manual.
Electrical safety
This tool is double insulated in 
accordance with EN 60335; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate.
To avoid the risk of electric shock, do not immerse the cord, plug or
motor unit in water or other liquid.
Unpacking
•Remove all packaging from the appliance,
•Clean the appliance before first use.
Use
Warning! Always place the appliance on a flat, clean and
Operating controls
The processor and blender control dials have the following settings:
P- Pulse
0 - Off
1 - Speed 1 (Low)
2 - Speed 2 (Middle)
3 - Speed 3 (High)
The speed can be adjusted while the processor or blender is in use.
Warning! Do not operate the food processor continuously for more than 2 minutes. After operating the appliance continuously for 2 minutes, let it cool down for at least 2 minutes before operating it again.
Using the processor bowl
The processor bowl (8) can be used to whisk, or chop large quantities of food. See the section “Quantities and processing times” in this manual.
•Place the appliance on a flat surface and make sure that the speed selector is set at 0 (off).
•Make sure that the blender cap (1) or the blender jar (5) is locked in position in the blender recess (2).
•Rotate the processor bowl lid (10) in an
•Remove any accessories from the processor bowl (8).