English
•Select the required accessory.
•Make sure that the processor bowl (8) is locked in position by rotating it in a clockwise direction.
The chopping blade (14), the knife frame
(13)or the whisk (19) can be placed directly over the central column of the processor bowl (8). Rotating these items slowly will align the hexagonal hole and drive on the motor spindle (4).
•Add the ingredients and place the lid (10) on the bowl (8), rotating it clockwise until it locks in place. The long tab on the lid
(10)will engage in the slot in the upper housing.
•Connect the appliance to the electrical supply and select speed 1, 2, 3 or Pulse as required.
Additional ingredients can be added through the kidney shaped slot in the bowl lid (10) after removing the pusher (9). The pusher must be used to guide the ingredients into the path of the blade.
Warning! Always use the pusher to assist in processing food, never use your fingers.
Using the blades
Warning! Make sure the food processor is unplugged from the power source and switched off before fitting or removing accessories.
The blades
•Place the required blade on the blade carrier (13), and slide it forward until the tab fits into the slot. The blade must then be gently pushed until it locks in position. To remove the blade, grip the rim underneath it and pull it away from the blade carrier (13).
•Once assembled, remove the processor bowl lid (10) and, using the finger holes in the blade carrier (13) place the blade carrier over the motor spindle (4).
•Replace the processor bowl lid (10).
Ingredients can be added through the
Using the blender
Use the blender jar (5) for the fine blending of raw ingredients and blending of cooked ingredients to a very smooth consistency.
Note: There is a convenient measuring cup fitted in the blender lid (7).
See the section “Quantities and processing times” in this manual.
Warning! Make sure the food processor is unplugged from the power source and switched off before placing or removing accessories.
•Remove any accessories from the processor bowl (8) and refit the lid (10) and the pusher (9).
•Remove the cap (1) by rotating it in an
•Add the ingredients to the blender jar (5) and fit the lid (7), rotating it in an anti- clockwise direction until it locks in place. Do not exceed the maximum mark.
•Place the blender jar (5) in the recess (2) and rotate it in a clockwise direction until it locks in place.
Note: The blender jar cannot be fitted to the appliance unless the lid (7) is correctly fitted to the jar.
Note: The blender lid (7) cannot be removed when the blender jar (5) is fitted to the appliance.