Nuvo NV-E6MS, NV-E6XS manual Series Amplifier Front

Page 4

E Series Amplifier Front

1

2

3

1POWER Button: The amplifier is designed to be turned on and remain on. The power button supplies power to the system. Each zone can then be turned on or off independently.

2Stand By LED: This blue LED (light-emitting diode) will remain lit as long as the power button is engaged. Note that once the system is installed, it is designed to be left on.

3Zone Status LED: These LEDs indicate the power status of each zone. Once in standby mode, each zone has the ability to be powered up or down independently.

Page 2

Image 4

Contents Series NV-E6MS/NV-E6XS Nuvo Technologies Inc NV-E6MS Main Audio Distribution System Description NV-E6XS Expander Audio Distribution System DescriptionSeries Amplifier Front Series Amplifier Back Panel 3 4 5Series Keypad Nuvo RC1 Remote Control IR EmitterInstalling and Terminating Cables Pin #III. Connecting the E6M to the E-Z Port II. Installing the E-Z Port HubCat-5 cables from keypads Connecting the IR Emitters IV. Attaching Source Equipment to the E6MVI. Connecting the E6M to the E6X VII. Installing the NV-EKP KeypadsE6M Amplifier NV-DI3 Datalink Cable NV-AI2 Audiolink CableVIII. Setting the NV-EKP DIP Switches DIP switches ZoneSwitches 5 & 6, Zone EQ Presets +4dB Boost At 100Hz At 10kHz +4dB Boost At 100Hz and 10kHz Flat ResponseUsing the Mute and Unit On Pins NV-RC1 Remote Learning RemoteXI. MPU Diagnostic LEDs XIII. NV-MI1 Mute Interface XII. Changing the Buttons on the NV-EKPMI1 is not supplied with the E6M or the E6X packages Troubleshooting Symptom Probable CauseNuvo NV-E6M Specifications WarrantyDelhi Pike, Cincinnati, OH USA