Nuvo NV-E6XS, NV-E6MS manual Series Amplifier Back Panel, 3 4 5

E Series Amplifier Back Panel

	ZONE 1				ZONE 2
L	R	LEFT	RIGHT	L	R	LEFT	RIGHT
		- +	- +			- +	- +
LINE OUT		20W/8 OHM X2		LINE OUT		20W/8 OHM X2

INPUT SOURCES

L

R

1 2 3 4 5 6

	ZONE 3				ZONE 4
L	R	LEFT	RIGHT	L	R	LEFT	RIGHT
		- +	- +			- +	- +
LINE OUT		20W/8 OHM X2		LINE OUT		20W/8 OHM X2

AUDIO OUTPUT

CONNECT TO NV-E6X

DIAGNOSTIC

CONTROL

ZONE 5

ZONE 6

L

R

LEFT

RIGHT

L

R

LEFT

RIGHT

REFER TO MANUAL MUTE UNIT ON

- +

- +

- +

- +

0

1

2

3

N.O. G +12V G

LINE OUT

20W/8 OHM X2

LINE OUT

20W/8 OHM X2

-INPUT- -OUTPUT-

IR EMITTER OUTPUTS

NETWORK

DIGITAL OUTPUT

+12V OUTPUT PULSE

CONNECT TO

CONNECT TO

NV-EZP

NV-E6X

ODD NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)

EVEN NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)

1 2 3 4 5 6 SUM

MODEL NV-E6M

SIX SOURCE SIX ZONE

AUDIO DISTRIBUTION SYSTEM

120V 60Hz 300W

KUSTOM INC. CINCINNATI, OH USA

0215

1 2 3

1Audio Source Inputs:

2Preamp LINEOUTS:

3Speaker Outputs:

4 Audiolink:

5Routed IR Outputs:

6Diagnostic LEDs:

7RJ45 Input:

8 Datalink:

9Mute Input:

10 AC:

4 5 6 7 8 9 10

The E Series amplifier accepts up to six audio sources. These can accept any audio component capable of supplying a line level signal.

Preamp lineouts for each zone allow you to easily use an additional amplifier to power additional speakers in a zone. Only use one pair of 8-ohm speakers per zone.

Individual stereo speaker outputs provide 20 watts output per channel to each zone.

This multi-pin connection is used to transfer the audio information from the E Series main amplifier to the expander amplifier. This output is used to expand the system to twelve zones.

These outputs transfer IR signals from the zones to your source components. They are routed odd and even so that when source

1, 3, or 5 is selected at any of the keypads, the IR outputs 1, 3, and 5 all flash IR commands. Similarly, when source 2, 4, or 6 is selected at any of the keypads, the IR outputs 2, 4, and 6 all flash. The “Sum” output always flashes IR commands regardless of the source selected.

These four LEDs indicate the operation of the system’s MPU. They also indicate correct communication through the system.

A single Cat-5 wire terminated with an RJ45 connector carries all the information from the individual zones to the main amplifier.

This multi-pin connection transfers all the digital information from the main amplifier to the expander amplifier. This output is used to expand the system from six to twelve zones.

This input temporarily mutes the system when the pins are shorted by a dry contact closure.

Detachable power cord connects the system to an external AC power supply.

Page 3