Hobart HPGF15 manual Remove Bolt

Page 21

EXHAUST VENT

1-1/4" DIA. EXHAUST PIPE

DRAIN PIPE

EXHAUST TANK

Fig. 21

REMOVE BOLT

PL-40939-2

Fig. 22

5.Remove 4 screws holding exhaust tank in place (see Fig. 21) and remove exhaust tank.

6.Flush exhaust tank with hot water.

7.Reverse procedure to reinstall exhaust tank.

– 21 –

Image 21

Contents Truct For Your Safety Important for Your SafetyTable of Contents Unpacking InstallationInstallation Codes and Standards AssemblyLocation Installing Casters GAS Connections Exhaust PipeFlue Connections Testing the GAS Supply SystemElectrical Connections Lighting InstructionsPL-40937-1 PL-40936-1 Before First USE OperationTurning the Fryer on Filling the Kettle with Liquid ShorteningFrying Procedure for ALL Foods Power Failure HIGH-LIMIT SwitchTurning the Fryer OFF Extended ShutdownSuggested Cooking Guide PRESSURE-RELIEF ValveTemp FoodOther Items Which May Be Prepared in the Pressure Fryer Using the HMF50 or HMF85 FilterTemp Time Food MinFiltering Oil at the End of the Production Day Cleaning Daily Cleaning Stainless SteelAluminum Kettle Weekly Cleaning More Often if Required Solenoid Assembly Fig Cleaning After Every Production Period Exhaust TankKettle Tilt Lid Pressure-Relief Valve Monthly Cleaning Exhaust TankRemove Bolt LID O-RING Seal Replacement MaintenanceOther O-RING Seal Replacements Kettle Pressure-Regulator AssemblyVent Cleaning Port Plug ScrewTroubleshooting Symptom Possible CausesLid will not lock do not Operate Fryer