4.Remove the four bolts securing the motor mount to the frame, then remove the motor and mount assembly from the unit. NOTE: It is possible to replace a motor or the microswitch without removing the motor and mount assembly, but it is much more difficult.
5.Dismount the motor or microswitch as shown below and install the replacement.
NOTE: The right motor and microswitch dismount in the same way as the left.
Loosen setscrew in bottom of cam (bell crank).
6. Reverse Steps 1-4 to complete the procedure.
7.3.10 Replacing the Cookpot
1.Drain the cookpot and disconnect the unit from the electrical power supply.
2.If so equipped, remove the faucet assembly from the cooker in accordance with Steps
3.Remove the screws from the upper corners of the control panel and open the panel by swinging it downward.
On units with manual (thermostat) controls:
a.Disconnect the water level sensor leads at the cookpot terminals. Disconnect all wiring from the control panel switches and light, and then remove the control panel from the unit.
b.Unplug the 4- and
c.Remove the interface board bracket from the unit.
d.Remove the temperature probe from the cookpot in accordance with Steps 4 through 6 of Section 7.3.6 (Units with Manual (Thermostat) Controls).
e.Remove the thermostat mounting bracket with thermostat attached.
On units with computer controls:
a.Disconnect the water level sensor leads at the cookpot terminals. Disconnect all wiring to the Skim switch (and to the Faucet switch, if present). Unplug the