Frymaster 8196345 manual Replacing an Ignition Module

1.9.4 Replacing an Ignition Module

1.Disconnect the fryer from the electrical supply.

2.Lift up on the bezel to disengage the tabs on its lower edge from the control panel frame.

3.Remove the top two screws in the upper corners of the computer.

4.Swing the computer out from the top and allow it to rest on its hinge tabs.

5.Disconnect the wires from the ignition module, marking or making a note of the wires and terminals to facilitate reconnection.

6.Remove the four ignition module screws and pull the module from the component box.

7.Move the spacers to the new module.

8.Reverse the procedure to install the replacement module.

1.9.5 Replacing an Ignitor Assembly

DANGER

Drain the frypot or remove the handle from the drain valve before proceeding further.

1.Disconnect the fryer from the electrical supply.

2.Disconnect the flame sensor wire by carefully pulling its push-on terminal from the terminal strip on the ignitor. Disconnect the gas enrichment tube at the ignitor-end compression fitting. Disconnect the ignition cable from the ignitor by grasping its boot and gently pulling toward you. (See photo below)

Flame Sensor Wire

Gas Enrichment Tube

Ignition Cable

3.Remove the sheet metal screws securing the ignitor to the mounting plate and pull the ignitor from the fryer.

4.Reverse the procedure to install the replacement ignitor.

1-9