Frymaster 8196345 manual Probe Resistance Chart, ATO Automatic Top-Off Service Procedures

relay marking the wires to ease reassembly. Once replaced, reconnect the power. When replacing a filter relay in the transformer, ensure the 24VAC relay (8070012) is used.

1.12Probe Resistance Chart

Probe Resistance Chart

For use with Protector® Series fryers manufactured with Minco Thermistor probes only.

F	OHMS	C
60	1059	16
65	1070	18
70	1080	21
75	1091	24
80	1101	27
85	1112	29
90	1122	32
95	1133	35
100	1143	38
105	1154	41
110	1164	43
115	1174	46
120	1185	49
125	1195	52

F	OHMS	C
130	1204	54
135	1216	57
140	1226	60
145	1237	63
150	1247	66
155	1258	68
160	1268	71
165	1278	74
170	1289	77
175	1299	79
180	1309	82
185	1320	85
190	1330	88
195	1340	91

F	OHMS	C
200	1350	93
205	1361	96
210	1371	99
215	1381	102
220	1391	104
225	1402	107
230	1412	110
235	1422	113
240	1432	116
245	1442	118
250	1453	121
255	1463	124
260	1473	127
265	1483	129

F	OHMS	C
270	1493	132
275	1503	135
280	1514	138
285	1524	141
290	1534	143
295	1544	146
300	1554	149
305	1564	152
310	1574	154
315	1584	157
320	1594	160
325	1604	163
330	1614	166
335	1624	168

F	OHMS	C
340	1634	171
345	1644	174
350	1654	177
355	1664	179
360	1674	182
365	1684	185
370	1694	188
375	1704	191
380	1714	193
385	1724	196
390	1734	199
395	1744	202
400	1754	204
405	1764	207

1.13 ATO (Automatic Top-Off) Service Procedures

The automatic top-off system is activated when the oil level falls below a sensor in the rear of the frypot. The signal is sent to the ATO board to engage the solenoid to the frypot and turn on the ATO pump. The pump draws oil from the JIB (Jug In Box) to a port in the rear of the frypot. Once the oil level has satisfied the sensor, the pump and solenoid turn off.

The ATO board is located inside the box, behind the JIB (see Figure 1). The power for the ATO board is supplied from the transformer box. The power passes through the transformer inside the ATO box to the board.

Figure 1

1-29