under underneath.. Avoid side airbag locations on back pillars and above the doors.. Airbag locations are marked with “SRS” logos.. Be careful not to crimp or cut the cable..
4.Bring the cable out from the trim near the front of the cabin and route it under the carpet toward the dashboard or console.. Coil any excess cable in a hidden location, such as under the carpet, keeping it away from any vehicle pedals or controls.. Secure the excess cable with wire ties (purchased separately)..
5.Bring the end of the cable out at the PowerConnect Vehicle Dock location.. Leave yourself enough cable so you can easily connect it to the antenna connector of the dock..
6.Continue with “Step 5: Connect the Magnetic Mount Antenna and PowerConnect Power Adapter” on page 37..
•Pickup Truck:
1.Use a blunt plastic putty knife
or similar blunt tool to lift the rubber molding around the windshield and tuck the antenna cable underneath it..
2. Continue tucking the cable underneath the windshield molding around the windshield to the lowest corner..
3. At the lowest corner of the
35