Vehicle Installation
•Sedan/Coupe With Antenna Placed at the Rear of the Roof:
1.Feed the antenna cable from the antenna underneath the rubber molding around the rear window.. Use a blunt plastic putty knife or similar blunt tool to lift the rubber molding around the rear window and tuck the antenna cable underneath the molding.. Route the antenna cable around and down the window to the lowest point.. If your rear window does not have rubber molding, we recommend consulting a professional installer..
2.Route the antenna cable out of the window molding and into the rubber weather stripping around the trunk opening.. Lift the weather stripping from the opening and tuck the cable inside it, then replace the weather stripping.. To avoid sharp bends in the cable, run the cable inside the weather stripping for a few inches, then remove the cable from the weather stripping inside the trunk.. Keep the cable away from hinges, gears, etc.., that could damage it..
3.Route the cable out from the rubber weather stripping and along the trunk wall.. Continue
routing the cable into the vehicle cabin through a conduit or along an existing wiring harness..
4. Route the cable through the main cabin area under the interior trim, towards the front of the vehicle.. Use a blunt plastic putty
30