Jenn-Air W10183782A manual Install Side Panel

4.The door stop is located on the top hinge.

A

B

C

A. Door stop screw “A”

B. Door stop screw “B”

C. Door stop

5.Remove the 2 door stop screws.

■To remove the outer screw (“A”):

With the door closed, firmly press the L-shaped bracket towards the center of the refrigerator until the screw is exposed.

■To remove the inner screw (“B”):

Open the door 90° and the L-shaped bracket will expose the screw.

A

B

A. Door stop screw “A”

B. Door stop screw “B”

6.Reverse or rotate the door stop to the desired position as shown below.

NOTE: For Overlay Series models, rout the hinge side of the custom door panels to a radius that is equal to at least half the thickness of the panel if a 130° door swing is desired.

130° 110°

90° 90°

Left-hand as shown; Right-hand reversed

7.Replace the door stop screws and tighten.

8.Check that the door can open freely.

Install Side Panel

If the built-in area depth is 25" (63.5 cm) or more, the side panels can be installed inside the side trim or attached to the outside of the side trim.

IMPORTANT: Jenn-Air is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service.

1.For the inside side trim piece, slide the front edge of the routed side panel into the trim piece.

2.Nail the rear edge of the panel to the support board.

A

B

A. Support board

B. Side trim piece

26