Jenn-Air JGR8855 Maintenance, Light, Oven Door, Panel _Q l, Storage Drawer, l_lgnt, _/ /_fi_

Maintenance

@ • @ • • • •	• 4_ • • • • 4_ @ @ • _ • • • •	• • • @ • • • • 4_ @ @ _ # @ • • •
Maintenance	Oven	Light
Oven Door

To remove:

1.When cool, open the oven door to the first stop position (opened about foarinches).

2. Grasp door at each side. Do not use the door handle to lift door.

3. Lift up evenly until door clears hinge arms.

To replace:

1. Grasp door at each side.

2. Align slots in the door with the

hinge arms on the range.

3. Slide the door down onto the hinge arms until the door is com- pletely seated on the hinges.

Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.

NOTE: The oven door on a new range may feel "spongy" when it is closed. This is normal and will decrease with

use.

Panel _Q l[

l_lgnt

To replace panel light bulb:

Grasp the top trim of the back panel with your thumbs under the front edge and pull outward while lifting the trim. Remove the bulb and replace it with an 18 watt fluorescent tube. Snap

the top trim back into place and restore the power. Reset the clock.

_

To replace oven light bulb:

1. When oven is cool, hold bulb cover in place, then slide

wire retainer off cover.	SuL_CovE_
NOTE: Bulb cover will fall	_	_::,,,
if not held in place while	///_/_//_'_J'-'Z
removing wire retainer.	/_/ (/_fi_	---/	_	}

2.Remove bulb cover and /_

light bulb.			_v_w,RE
3. Replace	with a 40 watt		R_TA'NeR
appliance		bulb.
5. Reconnect		power to range. Reset clock.

Storage Drawer

4. Replace bulb cover and secure with wire retainer.

The storage drawer can be removed to allow you to clean under the range.

To remove:

1. Empty drawer and pull out to the first stop position. 2. Lift up the front of the drawer.

3. Pull out to the second stop position.

4. Grasp sides and lift drawer up and out.

To replace:

1.Fit the ends of the drawer glides into the rails in the range.

2.Lift up front of drawer and gently push in to the first stop position.

3.Lift drawer up again and push until drawer is closed.

/