Marmitek manual Mounting Instructions, Neutral 2.Phase, MICROMODULE AWM2

Page 5

"address +1" will be transmitted (e.g. when A3 is programmed as the base address then the Marmitek X10 address A4 will be sent by using input 2). If the status in the MicroModule was ON, an OFF command will be transmitted. If the status in the MicroModule was OFF, an ON command will be transmitted. Through this transmission, other Marmitek X10 modules can be switched remotely over the power line or Macro’s setup in the computer interface can be activated.

Mounting Instructions

WARNING! ALWAYS SWITCH OFF THE MAIN MASTER SWITCH BEFORE INSTALLING THE MICROMODULE.

To install the MicroModule AWM2 the following wiring is required at the module installation point.

1.Neutral

2.Phase 230V

3.Load. This wire runs directly to the load.

•Take the wall switch out of the wall outlet.

•Disconnect all wires from the switch.

•Pull an additional Neutral-wire in case this one is missing.

MICROMODULE AWM2

Image 5

Contents MicroModule AWM2 AWM2-201201with a built-inappliance module Marmitek X10 transmitter for 2 addressesMicroModule AWM2 appliance module Applications Marmitek MicroModule AWM2Functions MICROMODULE AWM2Description of the Marmitek MicroModule wires Color code wire connectionsBlue Neutral 0 wire Red Input 2, second addressMICROMODULE AWM2 1.Neutral 2.PhaseMounting Instructions Brown Phase Load NeutralBlue Exit setup mode Activate the setup modeProgramming MICROMODULE AWM2defaults CommandFactory ProgrammableMICROMODULE AWM2 Sample 1. Program the Marmitek X10 address E4Sample 2. Program the function All Units Off Technical specifications Gerätemodul Anwendungen Marmitek MicroModul AWMFunktionen MICROMODULE AWM2Blau gemeinsme Null Farbcode der AnschlussdrähteRot Eingang 2, erstfolgende Adresse Null Phase Schaltkabel. Auf dieses Kabel ist dieEinbau Belastung angeschlossenNehmen Sie den Schalter aus dem Einbaurahmen MICROMODULE AWM2 ProgrammierenAktivieren Programmierstand Aktivieren und aufheben des Programmierstandes Aufheben ProgrammierstandProgrammiern der Adresse und der Optionen BefehlMICROMODULE AWM2 Beispiel des Programmierens der Adresse E4Achtung Technische Angaben apparaatmodule Toepassingen Marmitek MicroModule AWMFuncties MICROMODULE AWM2Blauw gemeenschappelijke 0 draad Kleurcode aansluitdradenInbouw/montage Rood Ingang 2, eerst opeenvolgend adres1.Nul 2.Fase MICROMODULE AWM2Rood Activeren programeerstand ProgrammerenOpheffen programeerstand MICROMODULE AWM2Programmeren van de het adres en de opties CommandoMICROMODULE AWM2 Voorbeeld van het programmeren van het adres E4Let op Technische gegevens MICROMODULE AWM2