IMPORTANT: Use the
A 
B 
C 
D
F
| G |
E |
|
A. Plenum wiring box | D. Red wires |
B. White wire and green (or bare) | E. Cable from home power supply |
wire (from cooktop) | F. UL listed wire connector |
C. Black wires | G. UL listed or CSA approved |
| strain relief |
1.Disconnect power.
2.Remove wiring box cover from the cooktop plenum.
3.Remove the appropriate knockout for the size of the home power supply cable on the bottom side of the cooktop wiring box. Use a UL listed or CSA approved strain relief to connect home power supply cable to cooktop wiring box.
4.Connect the green (or bare) ground wire and the white wire from in the plenum wiring box to the white wire from the home power supply cable using the UL listed wire connectors.
5.Connect the 2 black wires together using the UL listed wire connectors.
6.Connect the 2 red wires together using the UL listed wire connectors.
7.Tighten screws on the strain relief.
8.Install cooktop wiring box cover on plenum wiring box.
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all your tools.
3.Dispose of/recycle all packaging materials.
4.Use a mild solution of liquid household cleaner and warm water to clean cooktop before use. Dry thoroughly with a soft cloth. For more information, see the “Cooktop Care” section of the Use and Care Guide.
5.Read “Cooktop Use” in the cooktop Use and Care Guide.
6.Reconnect power.
7.Use the Flow Tester Card provided with your cooktop to check the airflow (see card for
NOTE: If the cooktop does not work after turning on the power, check that a circuit breaker has not tripped or a household fuse has not blown. See “Troubleshooting” section in the Use and Care Guide for further information.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your cooktop.
11