Make sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA
A copy of the above code standards can be obtained from:
National Fire Protection Association
1Batterymarch Park
Quincy, MA
CSA International
8501 East Pleasant Valley Road
Cleveland, OH
Before You Make the Electrical Connection:
To properly install your cooktop, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.
■A
(30" [76.2 cm] models), fused on both sides of the line.
■The cooktop should be connected directly to the junction box in the cabinet through the flexible metal conduit. The flexible, armored cable extending from the fuse box or circuit breaker box should be connected directly to the cooktop wiring box.
■Locate the junction box in the cabinet to allow as much slack as possible between the junction box and the cooktop so that the cooktop can be moved if servicing becomes necessary in the future.
■A UL listed or CSA approved conduit connector must be provided at each end of the power supply cable (at the cooktop wiring box and at the junction box in the cabinet).
■If the house has aluminum wiring follow the procedure below:
1.Connect a section of solid copper wire to the pigtail leads.
2.Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices.
INSTALLATION INSTRUCTIONS
Prepare Cooktop
Decide on the final location for the cooktop.
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop. Failure to do so can result in back or other injury.
1.Open product as instructed on product packaging.
2.Remove shipping materials and tape from cooktop.
3.Remove vent grille and grates if present.
B C D
A
A. Vent grille (already removed)
B.Grates
C.Removable grease filter
D.Radiant element cartridge
4.Remove the removable grease filter by lifting the filter out.
5.Using 2 or more people, remove the cooktop from the carton.
6.Use foam end caps from the packaging as a work surface for the floor or countertop.
7.Using 2 or more people, place the cooktop on the foam end caps.
8.Avoid placing the cooktop face down on the control knobs.
9.Turn tie down bolt on each end of cooktop burner box bottom counter clockwise so the bolt does not protrude beyond the side wall of the burner box bottom.
8