AEG 50800 manual Start the wash programme, Changing/Interrupting/Cancelling, Wash Programme

Page 22

Operating Instructions

Start the wash programme

0 1. Check that the dishes and cutlery are loaded into the dishwasher in such a manner that the spray arms are free to rotate.

2.Open the tap fully.

3.Shut the door.

4.Press the ON/OFF button. The ON/OFF button indicator illuminates.

5.Press the programme button for the desired programme (see "Pro- gramme Table"). The programme indicator illuminates. The selected programme begins after around 6 seconds. The time remaining until the end of the programme is displayed on the multi-display, the time calculated is dependent on the load in the dish racks.

With automatic programme adjustment this residual time count can be stopped or corrected if necessary (load quantity, degree of dirtiness, etc.) using the dishwasher control.

3

If fault messages are displayed on the multi-display after the start of

 

the programme, please read the "What to do, if..." section.

 

Changing/Interrupting/Cancelling

 

the Wash Programme

3

Only change or interrupt a wash programme in progress if it is abso-

 

lutely necessary to do so. When the appliance is closed again, the air

 

that has entered is heated and expands significantly. As result water

 

may penetrate into the base of the appliance and trigger the leak pre-

 

vention system.

 

Changing the wash programme

3

If you want to change the wash programme within 6 seconds of mak-

 

ing a programme selection, briefly press the button for the new wash

 

programme.

 

If you want to change the wash programme at a later point in time, use

 

the following procedure:

0 1. Press the button for the new wash programme and hold it pressed. The indicators for both programmes now flash.

2.After a few seconds only the indicator for the new programme flashes. Release the programme button, the new programme is now running.

22

Image 22
Contents Ökofavorit Please read these user instructions carefully Tips on using the applianceDear customer Use of the appliance are marked with a clover leafContents Installation and Connection Instructions Installation, Connection and Placing into Operation Safety InstructionsChild Safety General Safety Correct UseDisposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of old appliancesAppliance Features and Control Panel Prior to using for the first time Control panelSalt Adjust the water softenerAdjust Hardness range of the water in your areaUse special salt Filling with Special Salt for the Water SoftenerFill with special salt Place the funnel supplied on the con- tainer openingWould damage the appliance Filling with Rinse AidThat you glasses are clear Fill with rinse aidAdjusting Rinse Aid Dosing Not be washed in the dishwasher Daily UseLoading cutlery and dishes For washing in the dishwasher the following cutlery/dishesLoading Cutlery Long, pointed items of cutleryLoad large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans and Large PlatesTo ease the loading of large items at Loading Cups, Glasses Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Raising the Upper BasketFilling with Detergent Fill with detergentBio Wash Programmes and Concentrated Detergents Selecting the Wash Programme Programme Table Wash Programme Changing/Interrupting/CancellingStart the wash programme Changing the wash programmeSetting or Changing the Start Delay Timer Emptying the Dishwasher Switching Off the DishwasherLoad Sensing Sensor Logic Immediately after the end of the programme. ThereforeCare and Cleaning Cleaning the FilterWhat to do, when Put the flat filter back in the base Washing compartmentError messages are displayed Malfunction Possible Cause RemedyDishes are still dirty Problems occur during use of the dishwasherWash results are not satisfactory Wrong wash programme was selectedRinse aid was not used Rinse aid container is empty Technical DataDishes are wet and dull Lower rinse aid dosingSample loading arrangements Upper basket Lower basket with cutlery basketCrushed when the dishwasher is in position Installing the DishwasherFree-Standing Appliances Unscrew the screws 1 from the elbows on the back side Permitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseExtension hoses Water drainDrain hose Sink outlet connectionElectrical connection Leak Prevention SystemAppliance is automatically pumped out Connections South Africa South AfricaOther Countries Hongkong Lthuania Russia Cyprus Lebanon OmanEstonia Latavia Poland Israel Malaysia Saudi ArabiaHungary Thailand Slovakia Rep South AfricaSyria Guarantee Conditions Guarantee ConditionsWeitere Kundendienststellen im Ausland Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Otros puntos de Postventa en el extranjeroService AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG