AEG 50800 Leak Prevention System, Electrical connection, Appliance is automatically pumped out

Page 35

Installation and Connection Instructions

	Leak Prevention System
	For protection from damage due to water leaks, the dishwasher is
	equipped with a leak prevention system, the AQUA CONTROL SYSTEM.
	In the event of a fault, the safety valve immediately interrupts the sup-
	ply of water to the appliance and the drain pump switches on. By this
	means water can neither escape nor overflow. The remaining water in
	the appliance is automatically pumped out.
1	The AQUA CONTROL SYSTEM also works when the appliance is switched
	off – the appliance must however not be disconnected from the mains.
Electrical connection
1	In compliance with electric company technical requirements for mains
	connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

If the appliance is hard-wired to the mains supply, then it must be safely isolated from the mains within the electrical installation with switches intended to ensure all-pole(N,L1)disconnection, shall be directly connected to the supply terminals and shall have a contact separation (fuses, cut outs, current trips or similar) of at least 3mm in each pole.

35

Image 35

Contents Ökofavorit Use of the appliance are marked with a clover leaf Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation Correct Use General SafetyDisposal of old appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Control panel Prior to using for the first timeHardness range of the water in your area Adjust the water softenerAdjust SaltPlace the funnel supplied on the con- tainer opening Filling with Special Salt for the Water SoftenerFill with special salt Use special saltFill with rinse aid Filling with Rinse AidThat you glasses are clear Would damage the applianceAdjusting Rinse Aid Dosing For washing in the dishwasher the following cutlery/dishes Daily UseLoading cutlery and dishes Not be washed in the dishwasherLong, pointed items of cutlery Loading CutleryTo ease the loading of large items at Loading Pans, Frying Pans and Large PlatesLoad large and heavily soiled dishes in the lower rack Loading Cups, Glasses Coffee Services Raising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Lowering the Upper BasketFill with detergent Filling with DetergentBio Wash Programmes and Concentrated Detergents Selecting the Wash Programme Programme Table Changing the wash programme Changing/Interrupting/CancellingStart the wash programme Wash ProgrammeSetting or Changing the Start Delay Timer Immediately after the end of the programme. Therefore Switching Off the DishwasherLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter Care and CleaningPut the flat filter back in the base Washing compartment What to do, whenMalfunction Possible Cause Remedy Error messages are displayedWrong wash programme was selected Problems occur during use of the dishwasherWash results are not satisfactory Dishes are still dirtyLower rinse aid dosing Technical DataDishes are wet and dull Rinse aid was not used Rinse aid container is emptyUpper basket Lower basket with cutlery basket Sample loading arrangementsFree-Standing Appliances Installing the DishwasherCrushed when the dishwasher is in position Unscrew the screws 1 from the elbows on the back side Connect the inlet hose Connecting the DishwasherWater Connection Permitted water pressureSink outlet connection Water drainDrain hose Extension hosesAppliance is automatically pumped out Leak Prevention SystemElectrical connection Connections South Africa South AfricaOther Countries Israel Malaysia Saudi Arabia Cyprus Lebanon OmanEstonia Latavia Poland Hongkong Lthuania RussiaSyria Thailand Slovakia Rep South AfricaHungary Guarantee Conditions Guarantee ConditionsOtros puntos de Postventa en el extranjero Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Weitere Kundendienststellen im AuslandService AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG