AEG 50800 manual Unscrew the screws 1 from the elbows on the back side

Page 32

Installation and Connection Instructions

•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:

–Unscrew the screws (1) from the elbows on the back side.

–Slide the work surface approx. 1cm to the rear (3) , lift at the front (4) and remove.

–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear

(5).

•The dishwasher must also be screwed on tightly to the work surface or to the adjoining units. This is essential to ensure the dishwasher does not tip.

1If the dishwasher is later used as a free-standing appliance, the original work surface must be re-mounted.

3 The plinth on free-standing appliances is not adjustable.

Image 32

Contents Ökofavorit Tips on using the appliance Dear customerPlease read these user instructions carefully Use of the appliance are marked with a clover leafContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation General Safety Correct UseDisposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of old appliancesAppliance Features and Control Panel Prior to using for the first time Control panelAdjust the water softener AdjustSalt Hardness range of the water in your areaFilling with Special Salt for the Water Softener Fill with special saltUse special salt Place the funnel supplied on the con- tainer openingFilling with Rinse Aid That you glasses are clearWould damage the appliance Fill with rinse aidAdjusting Rinse Aid Dosing Daily Use Loading cutlery and dishesNot be washed in the dishwasher For washing in the dishwasher the following cutlery/dishesLoading Cutlery Long, pointed items of cutleryTo ease the loading of large items at Loading Pans, Frying Pans and Large PlatesLoad large and heavily soiled dishes in the lower rack Loading Cups, Glasses Coffee Services Adjusting the Height of the Upper Basket Lowering the Upper Basket TypeLowering the Upper Basket Raising the Upper BasketFilling with Detergent Fill with detergentBio Wash Programmes and Concentrated Detergents Selecting the Wash Programme Programme Table Changing/Interrupting/Cancelling Start the wash programmeWash Programme Changing the wash programmeSetting or Changing the Start Delay Timer Switching Off the Dishwasher Load Sensing Sensor LogicEmptying the Dishwasher Immediately after the end of the programme. ThereforeCare and Cleaning Cleaning the FilterWhat to do, when Put the flat filter back in the base Washing compartmentError messages are displayed Malfunction Possible Cause RemedyProblems occur during use of the dishwasher Wash results are not satisfactoryDishes are still dirty Wrong wash programme was selectedTechnical Data Dishes are wet and dullRinse aid was not used Rinse aid container is empty Lower rinse aid dosingSample loading arrangements Upper basket Lower basket with cutlery basketFree-Standing Appliances Installing the DishwasherCrushed when the dishwasher is in position Unscrew the screws 1 from the elbows on the back side Connecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater drain Drain hoseExtension hoses Sink outlet connectionAppliance is automatically pumped out Leak Prevention SystemElectrical connection Connections South Africa South AfricaOther Countries Cyprus Lebanon Oman Estonia Latavia PolandHongkong Lthuania Russia Israel Malaysia Saudi ArabiaSyria Thailand Slovakia Rep South AfricaHungary Guarantee Conditions Guarantee ConditionsFurther after-sales service agencies overseas Autres agences étrangères assurant le service après-venteWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroService AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG