AEG 50800 manual Error messages are displayed, Malfunction Possible Cause Remedy

Operating Instructions

...Error messages are displayed.

•If fault code (2 is displayed on the multi-display or the ^ indicator is illuminated, you can probably rectify the fault yourself.

After rectifying a (2 fault and a fault related to the ^ indicator, press the button for the wash programme that has been started. The wash programme continues. If the fault code is displayed again, con- tact customer service.

•For all other faults, please contact customer service, stating the fault code.

Malfunction	Possible Cause	Remedy
The programme indica-	Tap is blocked or furred with	Clean tap.
	lime-scale.
tor for the selected
programme is flashing	The filter (where present) in
and the ^indicator is	the threaded hose fitting at	Clean the filter in the
illuminated:	the water inlet valve is	threaded hose fitting.
there is no water run-	blocked.
ning into the dish-	The water inlet hose is not
washer.		Check hose installation.
	correctly laid.
Fault code (2 is dis-	The siphon is blocked.	Clean siphon.
played on the multi-
display.
The programme indica-	The water drain hose is not	Check hose installation.
tor for the selected	correctly laid.
wash programme is
flashing.
Fault code (3 is dis-	The leak prevention system	Close the tap and contact
played on the multi-
	has been triggered.	customer service.
display.
	The [ indicator is only
	intended to remind you to
	check the filter in the dish-	The indicator goes out auto-
The [ indicator is	washer from time to time
	and, if necessary, to clean it.	matically on the start of the
illuminated.
	It illuminates at regular	next wash programme.
	intervals, independent of the
	amount of soiling of the fil-
	ter.

27