LR-300 Specifications
Architectural Specifications
The FM receiver shall be capable of receiving on 17 wide band channels and have a SNR of 80dB or greater. The receiver shall be capable of seeking channels. The device shall have a squelch. The device shall have an audio frequen- cy response of 63Hz to 15KHz, ± 3dB at 72MHz. The device shall incorporate a stereo headset jack that allows the user to plug in either a mono or stereo headset and listen to audio normally. The receiver shall incorporate automatic battery charging circuitry for recharging of NiMH batteries. The Listen
Specifications
| Specification |
| |
| RF Frequency Range | 72.025 - 75.950 MHz | |
| Number of Channels | 17 (wide band) | |
| Sensitivity | .6uV typical, 1 uV maximum for 12dB SINAD | |
RF | Frequency Accuracy | ± .005% stability 0° to 50°C (32° to 122° F) | |
Antenna | Uses earphone cable | ||
| |||
| Antenna Connector | 3.5mm connector | |
| Squelch | Automatic on loss of RF signal | |
| Compliance | FCC Part 15, Industry Canada | |
| ** All system specifications are wireless | ||
| System Frequency Response | 63Hz - 15kHz (±3dB) | |
| System Signal to Noise Ratio | SQ enabled: 80dB; SQ disabled 60dB | |
Audio | |||
| |||
| System Distortion | <2% total harmonic distortion (THD) at 80% deviation | |
| Output | 3.5mm connectors, unbalanced, 0dBu nominal output level, | |
| 16mW maximum, impedence 32 Ohms | ||
|
| ||
| Set Up Controls | Alkaline/NiMH batteries, SQ enable/disable | |
Controls | User Controls | Volume, SEEK (Channel SEEK is electronically lockable) | |
Programming | Channel selection can be locked by holding the | ||
| |||
| SEEK button for 5 seconds. | ||
|
|
44