AEG 34942G installation instructions Cut Out Size, Building over a cupboard or drawer

Page 17

Cut Out Size

The dimensions of the cut-out are given in the diagram.

500

860

470

830

	.
55	min
55

FO 2407

Building In

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2 (see next page).

Image 17

Contents 34942G/35940G/35941G/35944G During Use InstallationChild Safety Environmental Information ServiceContents Guide to Use the instructions Description of the Hob Mod G HOB Burners OperationHob Top Maintenance and CleaningPan Supports BurnersSomething Not Working? Symptom Solution0870 5 929 Service and Spare PartsEuropean Guarantee Guarantee ConditionsEngineers technical data Instructions for the InstallerBurner Location Important safety requirementsInstallation This book be ignored Gas ConnectionBuilding over a cupboard or drawer Cut Out SizeBuilding Building over a kitchen unit with door Place the sealing Fitting the hob to the worktopThis HOB Must be Earthed Electrical connectionsPermanent Connection Wiring diagramPreliminary Electrical Systems Check Fault FindingEarth Continuity Check Check gas supply at burner Ignition System / Gas IgnitionCommissioning Pressure TestingMethod Conversion from Natural Gas to LPG