Problem | Possible cause | Note/remedy |
|
|
|
When you press the p button, Ÿ© | The ceiling and side parts in the | You can only set the cleaning system if you have |
appears in the display. | cooking compartment are not self- retrofitted the | |
| cleaning. The cleaning system | and activated the cleaning system in the basic set- |
| cannot be run. | tings. See the Cleaning system section and the |
|
| Basic settings section. |
|
|
|
“”‰” appears on the display. | Automatic | Press any button. |
| activated. The oven stops heating. |
|
Error messages with “
If an error message with “ is shown in the display, press the 0 button. This cancels the error message. You may then have to
reset the time. If the error is shown again, call the
You can take remedial action yourself if the following error message is displayed.
Error message | Possible cause | Note/remedy |
|
|
|
“‹‚‚ | A button has been pressed for too | Press all buttons individually. Check that the but- |
| long. | tons are clean. If the error message remains, |
|
| please contact the |
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat- resistant, 40 watt spare bulbs can be obtained from our after- sales service or a specialist retailer. Only use these bulbs.
ã=Risk of electric shock!
Switch off the circuit breaker in the fuse box.
1.Place a tea towel in the oven when it is cold to prevent damage.
2.Unscrew the glass cover by turning it
3.Replace the bulb with one of the same type.
4.Screw the glass cover back in.
5.Remove the tea towel and switch on the circuit breaker.
Replacing the bulb in the left-hand oven light
If the bulb in the oven light fails, it must be replaced. Heat- resistant, 25 watt spare bulbs can be obtained from our after- sales service or a specialist retailer. Only use these bulbs.
ã=Risk of electric shock!
Switch off the circuit breaker in the fuse box.
1.Place a tea towel in the oven when it is cold to prevent damage.
2.Remove the glass cover. To do this, open the glass cover from the bottom with your hand (Fig. A). If the glass cover is difficult to remove, use a spoon as an aid.
3.Unscrew the bulb and replace it with one of the same type (Fig. B). When fitting the new bulb, make sure that it is screwed in straight.
4.Refit the glass cover. Make sure that the curvature in the glass is on the right. Insert the glass at the top and push it in firmly at the bottom (Fig. C). The glass cover will click into
place. |
5.Remove the tea towel and switch on the circuit breaker.
Glass cover
You must replace a damaged glass cover. Suitable glass covers may be obtained from the
18