Bosch Appliances 6806, TRUE, 6805, 4306, 4302, 6802 manual Interior Features

Page 25

H

23

Interior Features

Fig. 5-2

Fig. 5-3

Fig. 5-4

The Upper Rack Rails are made

To remove the Rail, disengage

The Upper Rack Guide Rollers

of stainless steel with a plastic

the End Cap by applying

are permanently attached to the

end cap.

outward pressure to the Cap’s

Tank and cannot be removed or

 

top tab, unclipping it from the

repaired.

 

Rail. Then slide the Rail out from

 

 

the Guide Rollers.

 

 

 

 

 

 

 

 

 

 

 

Fig. 5-5

The Door Gasket is press fit into a channel molded around the Tank.

Note: Two inches of overlap are left at each end of the Gasket to insure a proper seal.

Fig. 5-6

To remove the Gasket, simply pull it away from the Tank Channel.

To replace, press the ribbed end firmly into the channel until secure. No sealant or glue is required.

Service tip: To test for a bad Door Gasket, open the dishwasher door and insert a dollar bill, then close the door and pull the bill out. If the bill is snug the Gasket is good, if the bill slides out easily the Door Gasket may need to be replaced.

Image 25
Contents Bosch Introduction Table of Contents SHI Service Reminder DescriptionSHV Section Customer Service Technical Service Warranty / Technical SpecificationsModel / Serial Number Location NTC Product OverviewProduct Overview Page Section Operation 24.75 20.25 Cycle ChartTo Operate To Cancel a CycleType of dishware China Pots/pans SHU 5302/5304/5305/5306/5312/5314/5315/5316 3.8 2.5 26.9/18.9 22.7/15.9 20.4/14.4 13.5/9.5 0.8 3.2 7Fig Power Scrub Regular Delicate Page Section Rack System Rack System Interior Features Interior Features Water Level Interior Features Detergent / Rinse-Agent Dispenser Washability Washability / DryingDrying HOW this System FunctionsService Reminder Outer Door Removal Door Components Dispenser Operation Outer Door Removal Door Compoments Dispenser Operation Dispenser Removal To InstallTo Remove Important Service Note Facia AssemblyFacia Assembly Removal Door Latch Assembly Removal ON/OFF Switch RemovalControl Unit Removal Page Section = 7 8 2 9 = Base Components Front AccessibleBase Components Front Accessible Base Components Front Accessible Cut Away View Service Reminder Section Left Side Panel Removal Left Side AccessLeft Side Components Water Inlet / Discharge System Operation Code FillingDraining Water Inlet / Discharge System Removal Section Right Side Panel Removal Right Side AccessComponent Explanation Right Side ComponentsNTC Operation NTC Removal NTC Removal NTC Removal NTC Removal NTC is held in place by two locking tabs, items 1 Page Section Tank Removal Tank Removal Tank Removal Base Components Circulation Pump / Motor Removal Circulation Pump / Motor Removal Circulation Pump / Motor AssemblyHeater Assembly Removal Heater Assembly Removal Heater AssemblyAqua Sensor To Replace the Springs Door Spring RemovalPage Section SHI/U 43- Models DiagramDiagram Timer u Power Scrub Flow Switch Circulation Motor Economy BKBU-f4 BU-l6-4 GY-l6-1 BNBK-b-3 Economy NTC Control Unit l2 Ground PE Wiring Connectors I5 Control Unit Reed Switch e3 185˚F On/Off Switch a1 Door Switch e0 BSH Home Appliances