Honeywell KMA28 operation manual Bendix/King

Page 1

Installation and Operation Manual

BENDIX/KING®

KMA 28

FAA-Approved TSO C50c, C35d

JAA-Approved JTSO-2C35d, C50c

Audio Amplifier /Intercom/

Marker Beacon Receiver

Document P/N 006-10565-0000

REVISION 0, SEPTEMBER 2000

WARNING

Prior to export of this document, review for export license requirement is needed.

Honeywell International, Inc. 2000©

Copyright Notice

Reproduction of this publication, or any portion thereof, by any means without the express written permission of Honeywell International, Inc. is prohibited. For further information contact the Manager, Technical Publications; Honeywell Business & General Aviation, Olathe, Kansas 66061. Phone (913) 782-0400.

Image 1

Contents BENDIX/KING Table of Contents Cellular Interface Checkout Introduction Section I General InformationScope Equipment DescriptionTSO Approval Approval BasisTSO Compliance SpecificationsEquipment Supplied Intercom SpecificationsLicense Requirements Equipment Required but not SuppliedEquipment Installation Procedures Section II InstallationGeneral Information Unpacking and Preliminary InspectionConnector Assembly Mounting Rack InstallationCable Harness Wiring NoiseExisting PS Engineering PMA6000 installations Existing KMA-24 InstallationPower Communications Push-to-TalkUnswitched inputs Swap ModeIntercom wiring BacklightingPublic Address function Com 3 AudioMarker Installation Communications Antenna Installation Notes AdjustmentsWireless telecommunications interface Hook Switches KMA 28 Pin Assignments Unit Installation Post Installation CheckoutOperational Checkout Receiver Sensitivity Marker CheckoutCellular Interface Checkout Final InspectionAudio Selector Section III KMA28 OperationKey click Speaker AmplifierPublic Address PA Function Power Switch /Emergency EMG OperationMicrophone Selector Split Mode Swap Mode Switch from Com 1 to Com 2 remotelySplit Mode ICS Telephone ModeIntelliVox VOX-Squelch Intercom SystemMono headsets in Stereo Installation Volume ControlIntercom Modes Soft Mute and Soft Mute inhibit Telephone Operation if equipped with approved system Marker Beacon OperationWill lose intercom capability when it is in use Appendix a Installation Drawings Connector viewed from the rearTray Dimensions in inches Top View Tray Assembly Drawing Bottom Connector, J1 Appendix B Bottom Connector InterconnectJ2 TOP Connector Appendix C Top Connector InterconnectInstructions for FAA Form Instructions for Continuing AirworthinessConditions Section Conducted Tests