Honeywell KMA28 operation manual Equipment Required but not Supplied, License Requirements

Page 8

Bendix/King

KMA28

Audio Amplifier/Intercom/Marker Beacon Receiver

1.7EQUIPMENT REQUIRED BUT NOT SUPPLIED

a)Circuit Breaker: 1 ea. 3 amp

b)Speaker, 4 Ω

c)Headphone Jacks (Stereo, as Required)

d)Microphone Jacks (as Required)

e)Headphones, 150 Ω (Stereo), up to 6 as required

f)Microphones, up to 6 as required

g)Marker Antenna (75 MHz, VSWR <1:1.5, 50 ohm, and cable (RG400 R/U)

h)Interconnect Wiring

1.8LICENSE REQUIREMENTS

None

006-10565-0000

Page 1-5

Rev. 0, Sept. 2000

Image 8
Contents BENDIX/KING Table of Contents Cellular Interface Checkout Section I General Information IntroductionScope Equipment DescriptionApproval Basis TSO ApprovalSpecifications TSO ComplianceIntercom Specifications Equipment SuppliedEquipment Required but not Supplied License RequirementsSection II Installation Equipment Installation ProceduresGeneral Information Unpacking and Preliminary InspectionMounting Rack Installation Connector AssemblyCable Harness Wiring NoiseExisting KMA-24 Installation Existing PS Engineering PMA6000 installationsPower Communications Push-to-TalkSwap Mode Unswitched inputsIntercom wiring BacklightingCom 3 Audio Public Address functionMarker Installation Wireless telecommunications interface AdjustmentsCommunications Antenna Installation Notes Hook Switches KMA 28 Pin Assignments Operational Checkout Post Installation CheckoutUnit Installation Marker Checkout Receiver SensitivityCellular Interface Checkout Final InspectionSection III KMA28 Operation Audio SelectorKey click Speaker AmplifierMicrophone Selector Power Switch /Emergency EMG OperationPublic Address PA Function Swap Mode Switch from Com 1 to Com 2 remotely Split ModeSplit Mode ICS Telephone ModeIntercom System IntelliVox VOX-SquelchIntercom Modes Volume ControlMono headsets in Stereo Installation Soft Mute and Soft Mute inhibit Marker Beacon Operation Telephone Operation if equipped with approved systemWill lose intercom capability when it is in use Connector viewed from the rear Appendix a Installation DrawingsTray Dimensions in inches Top View Tray Assembly Drawing Appendix B Bottom Connector Interconnect Bottom Connector, J1Appendix C Top Connector Interconnect J2 TOP ConnectorInstructions for Continuing Airworthiness Instructions for FAA FormConditions Section Conducted Tests