Honeywell KMA28 operation manual Will lose intercom capability when it is in use

Page 27

Bendix/King

KMA28

Audio Amplifier/Intercom/Marker Beacon Receiver

When the intercom is in ALL mode, the pilot can speak on the phone only if the mic se- lector switch is in TEL position. All intercom positions will hear the telephone conversa- tion. Anyone who places his or her switch into the “off-hook” position will also be heard on the phone. All will hear selected audio. Com 1 audio is automatically heard in the headsets. The pilot will have transmit capability on Com 1, simply by using the PTT switch.

In CREW mode, the pilot and copilot may use the telephone, with their respective hook switch (the pilot selects TEL on the mic selector). Any passenger who places their switch into the off-hook position will also have access to the phone, and all four passengers will hear the conversation.

In ISO intercom mode, when the KMA28 is in the TEL mode, the pilot position is in the "Phone Booth." Only the pilot will hear the telephone, and only he will be heard. He will also have access to Com 1, and will transmit on that radio using the PTT. All selected audio is provided.

In all cases, only the pilot (and copilot in ALL or CREW) will hear the cellphone ring. At that time they can chose to allow a passenger to take the call, or answer the phone.

Note: Because the phone uses an intercom circuit, all stations on that circuit

will lose intercom capability when it is in use.

006-10565-0000

3-8

Rev. 0, Sept. 00

Image 27
Contents BENDIX/KING Table of Contents Cellular Interface Checkout Equipment Description Section I General InformationIntroduction ScopeTSO Approval Approval BasisTSO Compliance SpecificationsEquipment Supplied Intercom SpecificationsLicense Requirements Equipment Required but not SuppliedUnpacking and Preliminary Inspection Section II InstallationEquipment Installation Procedures General InformationNoise Mounting Rack InstallationConnector Assembly Cable Harness WiringCommunications Push-to-Talk Existing KMA-24 InstallationExisting PS Engineering PMA6000 installations PowerBacklighting Swap ModeUnswitched inputs Intercom wiringPublic Address function Com 3 AudioMarker Installation Adjustments Communications Antenna Installation NotesWireless telecommunications interface Hook Switches KMA 28 Pin Assignments Post Installation Checkout Unit InstallationOperational Checkout Final Inspection Marker CheckoutReceiver Sensitivity Cellular Interface CheckoutSpeaker Amplifier Section III KMA28 OperationAudio Selector Key clickPower Switch /Emergency EMG Operation Public Address PA FunctionMicrophone Selector Telephone Mode Swap Mode Switch from Com 1 to Com 2 remotelySplit Mode Split Mode ICSIntelliVox VOX-Squelch Intercom SystemVolume Control Mono headsets in Stereo InstallationIntercom Modes Soft Mute and Soft Mute inhibit Telephone Operation if equipped with approved system Marker Beacon OperationWill lose intercom capability when it is in use Appendix a Installation Drawings Connector viewed from the rearTray Dimensions in inches Top View Tray Assembly Drawing Bottom Connector, J1 Appendix B Bottom Connector InterconnectJ2 TOP Connector Appendix C Top Connector InterconnectInstructions for FAA Form Instructions for Continuing AirworthinessConditions Section Conducted Tests