Ensure that the water inlet hose does not become compressed while positioning the machine. Also, make sure that the machine does not stand on the electrical cable.
Ensure the machine is level when placed on the surface. Adjust the feet by twisting clockwise to raise the height of the machine, and
Water Connection
Ensure the machine is connected to a clean, cold running water supply.
Water inlet hose
Only use the water inlet hose supplied with this machine. Do not re- use old inlet hoses. Connect the water inlet hose directly to the water inlet tap. The pressure supplied by the tap should be a minimum of 0.03Mpa and a maximum of 1Mpa. If the water pressure is above 1Mpa, a pressure release valve should be fitted. After the connection is made, the tap should be turned on fully and checked for water tightness. For the safety of your machine, make sure you always turn off the water after each cycle.
Note: Aquastop water spouts are used in some models. In case of using aqua stop, a dangerous tension exists. Do not cut an Aquastop water spout. Do not allow an aqua stop spout to become twisted.
Water outlet hose
The water drain hose can be connected either directly to the water drain hole or to the sink outlet spigot. Using a special bent pipe, the water can be drained directly into the sink via hooking the pipe over the edge of the sink. This connection should be a minimum of 50cm
and at a maximum of 110 cm from the floor plane. If a drain hose longer than 4m is used dishes may remain dirty and warranty will
be void.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084