Description of Operating Sequence

1. Variable power cooking control

The coil of power relay B (RY1) is energized intermittently by the digital programmer circuit, when the oven is set at any power selection except for High power position. The digital programmer circuit controls the ON-OFF time of power relay B contacts in order to vary the output power of the microwave oven from ”Low” to “High” power. One complete ON and OFF cycle of power relay B is 22 seconds. The relation between indications on the control panel and the output of the microwave oven is as shown in table.

NOTE: The ON/OFF time ratio does not correspond with the percentage of microwave power since approximately 2 sec- onds are required for heating of magnetron filament.

2. Inverter Power Supply Circuit NEW H,V

This Inverter Power Supply Circuit supplies 4,000V DC to the magnetron tube from the line voltage,120v 60Hz AC input. functions as the H.V. transformer, the H.V.capacitor and H.V.Diode.

1.The AC input voLtage 120V 60HZ is rectified to DC voltage immediately.

2.DC voltage will be supplied to the switching devices called IGBT. These devices will be switched ON-OFF by the 20 to 40 kHz PWM. (pulse width modulation) signal from the microcomputer in the DPC.

3.This drives the High voltage transformer to increase up to 2,000V AC and approximately 3V AC by means of transformer.

4.Then the half-wave doubler voltage rectifier circuit, consisting of the HV diodes and Capacitors, generates the necessary 4,000V DC needed for the magnetron.

5.Output power of the magnetron tube is always monitored by the signal output from the current transformer built into the inverter ciruit.

6.Then this signal will be fed back to the microcomputer in the DPC to determine operating conditions and output necessary to control PWM signal to the inverter Power Supply to control output power.

Variable Power Cooking

		OUTPUT	ON-OFF TIME OF
POWER SETTING		OUTPUT	POWER RELAY B (RY1)
POWER SETTING		POWER(%)	POWER RELAY B (RY1)
		APPROX.
		APPROX.	ON (SEC)	OFF (SEC)
			ON (SEC)	OFF (SEC)

HIGH	P10	100%	22	0
	P9	90%	22	0
	P8	80%	22	0
MEDIUM-HIGH P7		70%	22	0
MEDIUM	P6	60%	22	0
	P5	50%	22	0
	P4	40%	22	0
MEDIUM-LOW	P3	30%	22	0
	P2	20%	15	7
	P1	10%	8	14
DEFROST	P3	30%	22	0

Inverter Turbo Defrost

	SELECTED	COOKING TIME
	WEIGHT	COOKING TIME
	WEIGHT

	1.0LB	4 min.28 sec.

	6.0LB	25 min.00 sec.
		25 min.00 sec.

3. Inverter Turbo Defrost

When this Auto Control feature is selected and the Start Pad is tapped:

(A)The digital programer circuit determines the power level and cooking time to complete cooking and indicates the operating state in the display window. Table shows the corresponding cooking times for respective serving by categories.

(B)When cooking time the display window has elapsed, the oven tums off automatically by a control signal from the digital programmer circuit.

- 9 -