SECTION 3
OPERATION
V. QUICK REFERENCE: TROUBLESHOOTING
SYMPTOM
light is lit, food product is
undercooked
Oven will not turn on at all
appears in display, oven is not heating
Oven will not heat
Oven is operating, but little or no air is blowing from air fingers
Conveyor moves with a jerky motion, or will not move at all
Food products are
overcooked or undercooked.
PROBLEM
The oven temperature ex- ceeded 650°F (343°C), and the burner was automati- cally shut down.
Electrical power may not be reaching the oven, or the controls may be set incor- rectly.
The oven did not reach 200°F (93°C) within
Controls may be set incorrectly.
Air fingers may have been reassembled incorrectly after cleaning.
Conveyor may be jammed on an object in the oven, or conveyor belt or drive chain tension may be incorrect.
Controls may be set incor- rectly.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
SOLUTION
Follow the procedures under Daily Shutdown Procedures in this section to shut down the oven. Contact your Middleby Marshall Authorized Service Agent to determine and correct the cause of the condition to prevent damage to the oven.
Check that the circuit breaker/fused disconnect is turned on.
Check that the "BLOWER" ( | ) Switch is in the “ON” ("I") |
position. |
|
Turn the "HEAT/CONVEYOR" ( | ) and "BLOWER" ( ), |
switches to the "OFF" ("O") position.
Wait for AT LEAST FIVE MINUTES before restarting the oven. Repeat the Daily Startup procedure.
Check that the Set Point is correctly set.
Check that both the "BLOWER" ( ) and "HEAT/CONVEYOR"
( | ) Switches are in the “ON” ("I") position. |
If the oven still will not heat,turn the "HEAT/CONVEYOR" (
) and "BLOWER" (
) switches to the "OFF" ("O") position. Wait for AT LEAST FIVE MINUTES before restarting the oven.
Repeat the Daily Startup procedure. Check that the Set Point is above 200°F (93°C).
Turn the oven to the “OFF” or “O” position, and allow it to cool. Disconnect electrical power to the oven.
Refer to Section 4, Maintenance, for instructions on reassem- bling the air fingers.
Turn the oven to the “OFF” or “O” position, and allow it to cool. Disconnect electrical power to the oven.
Check if the conveyor is blocked by an object inside the oven.
Refer to Section 4, Maintenance, for instructions on checking the conveyor and drive chain tension.
Check that the set temperature and bake time settings are correct.
IF THESE STEPS FAIL TO RESOLVE THE PROBLEM, CONTACT YOUR LOCAL MIDDLEBY MARSHALL AUTHORIZED SERVICE AGENT. A SERVICE AGENCY DIRECTORY IS SUPPLIED WITH YOUR OVEN.
22