Middleby Marshall PS624E Conveyor Reassembly Into Oven, Checking Conveyor Belt Tension

E. Conveyor Reassembly Into Oven

1. Lift conveyor and position it in oven as shown.

NOTE: Conveyor must be inserted into the drive end of oven.

SECTION 4

MAINTENANCE

F. Checking Conveyor Belt Tension

WARNING

Oven conveyor belt must be cool when adjusting belt. Do not adjust belt if HOT.

1.With the conveyor assembly in the oven, stand at one end of conveyor and check tension by lifting the conveyor

belt at the center of the oven chamber opening. The belt should not lift higher that 1″ to 2″ (75mm to 102mm).

2.If conveyor belt is still not under proper tension, an entire link must be removed. Use the following procedure “G. Conveyor Belt Link Removal” to remove a link. If conveyor belt is under proper tension proceed directly to “H. Attaching Drive Chain”.

Figure 4-19.

2. Reinstall the conveyor extension.

Conveyor Extension

Figure 4-21.

Figure 4-20.

31